TRENDnet TEG-PCBUSR User manual

TEG-PCBUSR
Quick Installation Guide

Table of Contents
Table of Contents
Version 08.24.2007
English ..................................................................................................... 1
1
2
6
1. Before You Start
2. How to Install .....................................................................................
................................................................................
Troubleshooting ........................................................................................

System Requirements
Application
Package Contents
1. Before You Start
English
1
?
?
?
T
Quick Installation Guide
Driver CD-ROM
EG-PCBUSR
?
?CD-ROM Drive
?CPU: 300MHz or Above/ 800MHz or Above
?
?Windows Vista/XP/2000/ME/98SE
PC CardBus Type II Slot
(Windows Vista)
Memory: 256MB RAM or above/ 512MB RAM or above (Windows Vista)
32-Bit Gigabit CardBus PC Card
(TEG-PCBUSR)
8-Port 10/100/1000Mbps
Gigabit Switch
(TEG-S8)
32-bit 10/100/1000Mbps
Copper Gigabit PCI Adapter
(TEG-PCITXR)
32-bit 10/100/1000Mbps
Copper Gigabit PCI Adapter
(TEG-PCITXR)

2. How to Install
English
2
Note:
l
The TEG-PCBUSR is hot-pluggable, you can connect or disconnect the
TEG-PCBUSR while the computer is on.
l
For Windows Vista, drivers will install automatically
l
For Windows ME and 98SE instructions, please refer to the User's Guide.
.
1. The Found New Hardware
Wizard appears, select No not
this time , and then click Next.
2. Insert the Driver CD-ROM into
your computer's CD-ROM Drive.
3. Select Install the software
automatically (Recommended)
and then click Next.
4. Select the proper driver and then
click Next. If you are using
Windows XP 64-bit, choose the
driver located in d:\winxp64. If you
are using Windows XP 32-bit,
choose the driver located in
d:\winxp.
Note: D:\ represents the drive letter that is assigned to your CD-ROM drive.
Windows XP

5. Click Finish.
Windows 2000
1. The Found New Hardware
Wizard appears. Click Next.
2. Select Search for a suitable
driver for my device
(recommended) and then click
Next.
English
3

4. Type in G:\WIN2K and then click
OK.
Note: G:\represents the drive letter that is assigned to your CD-ROM drive.
5. Click Next.
English
4
6. Click Yes.
3. Select Specify a location and
then click Next.

7. Click Finish.
Your installation is now complete.
For detailed information regarding the TEG-PCBUSR configuration and
advanced settings, please refer to the TRENDnet's website at
www.trendnet.com
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/register
Thank you for choosing TRENDnet
English
5

Q1:
A1:
Q2:
A2:
Q3:
A3:
Windows is unable to recognize my hardware. What should I do?
First, verify that your computer meets the system requirements as specified in
Section 1. Second, go to Start > Control Panel > Hardware > Device
Manager. In the list of device types, double-click on Network Adapters. If you
see the device with a yellow question mark or exclamation point next to it, double-
click on it, click on Drivers and click Update Drivers. Follow the Hardware
Update Wizard instructions as illustrated in Section 2. Third, if the device
manager fails to recognize the presence of a new networking adapter, verify that
the network adapter is firmly seated in the PC CardBus slot. Fourth, install the
adapter into another available PC CardBus slot
Windows recognizes my new hardware, but I'm unable to connect to my
network. What should I do?
First, verify that the RJ-45 Ethernet Cable is securely connected from your
switch or router to your network adapter. Second, verify that the LEDs on your
network card are lit. Third, verify that the TCP/IP settings are set to Obtain an IP
address automatically.
When I connect the adapter to a gigabit switch, I am not getting gigabit
speeds. What should I do?
Make sure you are using CAT-5e or CAT-6 Ethernet Cables. Some CAT-5
cables are not rated to run in Gigabit.
If you still encounter problems or have any questions regarding the TEG-PCBUSR,
please refer to the User's Guide included on the Driver CD-ROM or contact TRENDnet's
Technical Support Department.
6
Troubleshooting

Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.

Product Warranty Registration
TRENDnet Technical Support
US Canada
24/7 Tech Support
Toll Free Telephone: [phone]
Europe (Germany France Italy Spain Switzerland UK)
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Worldwide
Telephone: +(31) (0) 20 504 05 35
Toll Free Telephone: [phone]
.
. . . . .
Copyright ©2007. All Rights Reserved. TRENDnet.
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com/register
20675 Manhattan Place
Torrance, CA 90501
USA