TRENDnet TE100-S800i User manual

TE100-S800i
TE100-S810Fi
Quick Installation Guide

Español .....................................................................................................
Troubleshooting ........................................................................................
1
1
2
3
5
1.Antes de iniciar ..................................................................................
2. Cómo conectar ..................................................................................
3. Cómo utilizar el conmutador ..............................................................
Table of Contents
Version 10.13.05

Requisitos del sistema
TE
Cable de poderAC
Cable RS-232
Guía de instalación rápida
Guía del usuario en CD-ROM
100-S800i/TE100-S810Fi
Contenidos del paquete
1. Estaciones de trabajo con tarjetas de red
2. Protocolo TCP/IPinstalado en todas las estaciones de trabajo
3. Una navegador Web como Internet Explorer o Netscape Navigator
4. Un cable de red RJ-45 para conectar su estación de trabajo al
TE100-S800i/TE100-S810Fi
(TE100-S800i)
8-Port 10/100Mbps Layer 2 Managed Switch
or
(TEG-S810Fi)
8-Port 100Base-FX Layer 2 Managed Switch with 100Base-FX Port
Workstations with 32-bit PCI
Fast Ethernet Card
(TE100-PCIWA)
Accounting
Department
Internet
Servers with 32-bit PCI
Fast Ethernet Card
(TE100-PCIWA)
Servers with 32-bit PCI
Fast Ethernet Card
(TE100-PCIWA)
Sales
Department
8-port 10/100Mbps
Fast Ethernet Mini Switch
(TE100-S88Eplus)
5-port 10/100Mbps
Fast Ethernet Mini Switch
(TE100-S5Pplus)
8-port 10/100Mbps
Fast Ethernet Mini Switch
(TE100-S8P)
MIS
Department
100Mbps
Español
1
1. Antes de iniciar

1. Conecte el cable de alimentaciónAC a la
parte posterior del TE100-S800i/
TE100-S810Fi.
3. Verifique que los LEDs de PWR (Encendido)
despliegan una luz verde sólida.
2. Conecte el cable de red en la parte frontal
del conmutador y su PC.
Español
2
2. Cómo conectar

Español
3

Nota: Para más detalles sobre las características avanzadas, por favor
consulte la Guía del Usuario.
La instalación ha sido completada
7. Seleccione la opción apropiada
para configurar el conmutador
SNMP.
4. Haga clic en la pestaña General,
seleccione Protocolo de Internet
(TCP/IP) y luego haga clic en
Propiedades.Cambie la dirección
IP a 192.168.16.222 y haga clic en
OK para aplicar las
configuraciones.
6. Nombre de usuario: root
Contraseña: root
5. Abra su navegador Web, escriba
http://192.168.16.1, y luego pulse
Enter (Intro).
Español
4

Q1.
A1.
Q2.
A2.
Q3.
A3.
How come I cannot see any light from any of my LED's?
Your TE100-S800i/TE100-S810Fi is not getting any power. Make
sure that your surge protector or your outlet is getting power and make
sure that theAC Power cord is properly connected to your
TE100-S800i/TE100-S810Fi.
I changed my IP settings to 192.168.16.222 to access the switch, but I
still cannot get into the Web configuration page. What should I do?
Make sure there is no other network device using the same IP
address. Afterwards, consult the User's Guide to access the switch
through the Console Port. Once you reach the command line interface,
perform a factory reset and try again.
I performed a factory reset on the TE100-S800i/TE100-S810Fi, but I
still cannot access the web configuration page. What should I do?
If you are configuring more than one TE100-S800i/TE100-S810Fi,
then it is possible that you are experiencing IP conflict between these two
switches. Please configure each switch one at a time, and make sure you
assign a unique IP address to each switch.
If you have any questions regarding the TE100-S800i/TE100-S810Fi, please
contact TRENDnetTechnical Support Department.
5
Troubleshooting
Certifications
This equipment has been tested and found to comply with FCC and CE Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FORANY RADIO ORTV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TOTHIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’SAUTHORITY TO OPERATE THE EQUIPMENT.
Waste electrical and electronic products
must not be disposed of with household
waste. Please recycle where facilities
exist. Check with you Local Authority or
Retailerforrecyclingadvice.

Copyright ©2006. All Rights Reserved. TRENDnet.
3135 Kashiwa Street
Torrance, CA 90505
USA
TRENDnet Technical Support
Tech Support Hours
24/7 Toll Free Tech Support
Contact
Telephone: [phone]
Email: [email protected]
Contact
Tech Support Hours
Telephone:
Deutsch :+49 (0) 6331 / 268-460
Français :+49 (0) 6331 / 268-461
0800-90-71-61 (numéro vert)
Español :+49 (0) 6331 / 268-462
English :+49 (0) 6331 / 268-463
Italiano :+49 (0) 6331 / 268-464
Dutch :+49 (0) 6331 / 268-465
Fax: [phone] / 268-466
8:00am - 6:00pm
Middle European Time
Monday - Friday
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com
US/Canada Support Center European Support Center