TRENDnet TV-IP602WN User manual

Quick Installation Guide
TV-IP602WN
1.01

Table of Contents
Version 03.14.2011
English 1
1. Before You Start
2. 2
1
Hardware Installation and Configuration
Troubleshooting 8
Wireless Tips 9

1. Before You Start
Ÿ
Ÿ
ŸVGA Resolution: 800 x 600 or above
ŸWeb Browser: Internet Explorer (6.0 or higher)
ŸWireless Router (e.g. TEW-691GR)
ŸAn available DHCP Server –routers usually have a built-in DHCP server
A computer with a wired network adapter properly installed.
CD-ROM Drive
Package Contents
Ÿ
ŸCD-ROM (Utility and User’s Guide)
ŸMulti-Language Quick Installation Guide
Ÿ2 x 2dbi Detachable Antennas
ŸNetwork Cable (1.5m/5ft.)
ŸMounting Kit
ŸPower Adapter (12V DC, 1.5A)
TV-IP602WN
System Requirements
1
Supported Operating Systems CPU Memory
Windows 7 (32/64-bit)
Windows Vista (32/64-bit)
Windows XP (32/64-bit)
1.3GHz or above
1.3GHz or above
1.3GHz or above
1GB RAM or above
512MB RAM or above
256MB RAM or above

2. Hardware Installation and Configuration
1. Insert the Utility CD-ROM into your CD-ROM
drive.
2
Note: It is recommended that you configure the IP Camera from a wired computer.
2. Click Run autorun.exe (Windows 7/Vista only).
3. Click Setup Wizard.
4. Click Next. Then follow the Setup Wizard
instructions.
5. Click Close.

3
10. Select the IP camera and click Next. Verify
that the MAC address listed matches the MAC
address on your IP camera. The MAC address
is listed on the bottom of the TV-IP602WN .
Click Re-Scan if no cameras are detected.
9. Click Next.
7. Connect the provided network cable from one
of your Router's network ports to the Ethernet
port on the IP Camera.
8. Connect the Power Adapter to the IP Camera
and then to a power outlet.
11. Enter your ID and password. Then click Next.
By default:
ID: admin
Password: admin
6. Double click on the SetupWizard icon on your
desktop.
12. Configure the Camera Name and Camera
Time. Click Copy Local Time to automatically
configure the Camera Time to match your
computer. Then click Next.