tresoro DATAGUARD User manual

1. Visual and acoustic signals
Signal
Explanation
Comment
 Right code
 Wrong code or code denied
 Short beep
Long beep
LED green on
The lock open
LED red on
The lock closed
2. Power shut down mode
 
1
2

3. Opening the lock
 
1

2

3☼
4☼
4. Changing the master code
 
1

2

3

4

-Default factor master code is -6-7-8-9.
-
In order to change the master code, the unit must first be in the power shut down (sleep) mode.
-
you must wait 20 seconds before recommencing the process.
Enter our new 5-digit master code e.g.
11111
If an incorrect master code is input, the system will go to power shut down mode, following which
Enter “
*
” to activate the s stem from power shut
down mode.
Enter button "Open".
Enter our old 5-digit master code e.g.

1234
Enter the 4-digit user code e.g and then press
"Open".
- The lock will open and the indicator LED light will
show green.
- When the LED light goes off the bolt is full
retracted and door handle ma be pulled to open
the door.
- The lock will remain open for 7 seconds before
automaticall relocking. The LED light will confirm
this b showing red.
- The door can be slam closed and locked, while the
lock is in this position .
USER MANUAL DATAGUARD WITH E-LOCK
☼
For activation the lock, enter “ * ” and the s stem will
be sound beep, then the lock can be operated.
The lock will be power shut down mode condition
15 second after the locked position.
Enter “
*
” to activate the s stem from power shut
down mode.
Open
Open
*
*
*

. Changing the user code
 
1

2

3

4

-
Default factor user code is 1-2-3-4.
-
In order to change the user code, the unit must first be in the power shut down (sleep) mode.
-
you must wait 20 seconds before recommencing the process.
6. Changing the battery
a. Remove black plastic batter compartment cover (located at the base of the lock cover)
b pressing the plastic retaining latch of the cover.
b. Allow the batter and its attached leads to drop down and out of the batter compartment.
If it does not drop, gentl pull on the batter holder until it drops out.
c. Remove the batter holder cover and remove the batteries.
CAUTION! Hold onto the battery terminal to avoid pulling the wires out of the housing.
d. Replace with 4 x size “AA” (1,5 V) Alkaline batteries.
e. Gentl push the batter terminal and the leads completel into the lock housing.
f.
Re-Install the batter cover b placing one side of the cover in position first
and then gentl pressing the retaining clip into place.
If an incorrect user code is input, the system will go to power shut down mode, following which
Re-enter “ * ” to entering change user code mode.
Enter our 5-digit master code e.g.

Enter our new 4-digit user code e.g.
2222
Enter “
*
” to activate the s stem from power shut
down mode.
*
*