Tri-Tronics CLS-2 User manual

AUTOSET INDICATOR
Flashes GREEN during AUTOSET.
OUTPUT INDICATOR
Illuminates RED when outputs are ON.
Flashes when short circuit or overload detected.
ALIGNMENT MARKS
Indicates location of sensing machinism.
AUTOSET
r _BUTTON
1. Push and hold with gap in view for two
seconds for AUTOSET.
2. Tap UP (
r
_) to reduce threshold.
LT/DK
s
+BUTTON
1. Push and hold to toggle between light on or
dark on
2. Tap DOWN (
s
+) to increase threshold.
CLS-2
Instruction Manual
Features
Features and Options:
• One button AUTOSET (Gap Set)
• Adjustable Threshold
• Cable and Connector (M12 & M8) Versions
• Removable Stainless Steel Gap Plate
• Durable and Robust Anodized Aluminum Housing
• Bottom or side mounting configurations
How To Specify
1.Select Sensor: CLS-2
Smaller Clear Label Sensor
2.Select Output Type
N = NPN
P = PNP
L = NPN/PNP
3.Select Connection Type:
Blank = 4-wire 6.5ft cable (2.0m)
C = 4-pin M12 connector
M8 = 4-pin M8 connector
CLS-2
Smaller Clear Label Sensor
Output Type
Connection
Example: CLS-2 N C
www.ttco.com • 800-237-0946 1
Quick Start Simple Setup Start cPut the Gap in view, press and
hold the AUTOSET. This will result in a perfect setup 99% of the
time. If you have any false triggers, tap UP (
r
_) to reduce
threshold, or tap DOWN (
s
+) to increase threshold.

SUPPLY VOLTAGE
• 12 to 30Vdc
• Polarity Protected
Note: For use in Class 2 Circuits
CURRENT REQUIREMENTS
• 70mA @ 12Vdc, 35mA @ 30Vdc
DIGITAL OUTPUTS
• (1) NPN and/or (1) PNP (depending on
model) open collector output 150mA
Max; <2V Residual Voltage
• All outputs are continuously short circuit
protected
REMOTE AUTOSET INPUT
• Active high (PNP) or active low (NPN),
depending on model (1mA)
Note: Input not available on “L” models
DIAGNOSTIC INDICATORS
• Green LED AUTOSET Indicator-
Illuminates when sensor is powered
"ON"; flashes upon AUTOSET
adjustment
• Red LED Output Indicator– Illuminates
when the sensor’s output transistors are
“ON”.
Note: If output LED flashes on power
up, a short circuit condition exists.
PUSH BUTTON CONTROL
• Two (2) push button controls
• AUTOSET (for Gap AUTOSET)
• LT/DK (toggles between light on or dark
on)
• Manual threshold adjustment
HYSTERESIS
• Dynamic – adjusted by AUTOSET
RESPONSE TIME
• 225µs
REPEATABILITY
• 75µs
AMBIENT TEMPERATURE
• 4°C to 50°C (39°F to 122°F)
RUGGED CONSTRUCTION
• Chemical resistant, high impact
Aluminum housing
• Conforms to heavy industry grade CE
requirements
• Waterproof ratings: IP65*
*Presence of water on transducers will
prevent sensor from functioning. Full
functionality will be restored once
transducers are dry.
CONNECTIONS
• 4-Wire 6.5ft cable (2.0m)
• 4-Pin M12
• 4-Pin M8 connector
Specifications
RoHS Compliant
Product subject to change without notice
Connections and Dimensions CLS-2 Smaller Clear Label Sensor
www.ttco.com • 800-237-0946 070-0690, Rev. 1