2/5 Copyright 2013 triAngle lights
1.3 Product Features
▪ 48x5mm RGB leds (red:16, green:16, blue:16)
▪ 2 modes: Auto, Sound Active
2. SET UP
2.1 Mounting
With adjustable mounting double brackets, this unit may be wall
mounted, free standing, or clamp mounted.
IMPORTANT Safety cables must always be used. The safety
cable must be capable of holding 10 times the weight of the
fixture.
2.2 AC Power
The fixture is designed to work on 100V-240V 50/60Hz.
Warning All fixtures must be connected to circuits
with a suitable Earth Ground.
3/5 Copyright 2013 triAngle lights
3 OPERATION INSTRUCTIONS
3.1 Sound Mode and Auto Mode
The unit will run in sound active mode by default. If there is no music it
will switch to Auto mode automatically.
It will go into sleep mode after 5 minutes of auto run to save power.
Sound mode can be activated again from sleep mode via any sound
such as music, clap, or voice.
4.SERVICING
4.1 Fuse Replacement
1. Unscrew the fuse holder and remove the damaged fuse.
2. Replace with exact same type fuse and screw the fuse holder back in
its place.
4.2 Cleaning
To maintain optimum performance fixtures should be cleaned
frequently.
Unplug fixture from power and allow the fixture to cool down. Use a
vacuum or air compressor and a soft brush to remove dust collected on
the plastic cover or lens.
