Tripp Lite SmartPro SMX700HG User manual

Tripp Lite
1111 West 35th Street
Chicago, IL 60609 USA
Telephone: +[phone]
E-mail: [email protected]
Model #: SMX700HG
SmartPro Medical Grade .7kVA 230V Line interactive Tower UPS, full isolation, USB & Serial ports
Highlights
700VA line interactive tower UPS
Maintains 230V nominal output over an input range of 155 to 274V
Professional features include serial port, USB port, IEC320 plug & outlets,
built-in isolation transformer
Input: IEC320 C14 (230V 3.6A) / Output: 6 IEC320 C13 (230V)
Description
Tripp Lite's SMX700HG offers medical-grade UPS protection with built-in line interactive voltage regulation, intelligent monitoring and unattended
shutdown capability. Tested to CE/IEC 60601-1 as medical electrical equipment. Built-in isolation transformer with Faraday shield removes common
mode noise while maintaining full AC surge suppression in all modes. Resistant to electrostatic discharge. Includes high quality hospital-grade plug
and outlets. 700VA power handling capacity supports computers, inter-networking equipment and other critical loads during commercial power
failures. Line interactive voltage regulation corrects brownouts as low as 155V and overvoltages as high as 274 back to normal 230V levels, saving
battery reserves for use only during complete power failures. Includes 6 outlets, diagnostic LEDs and built-in USB & RS-232 communications ports
that work with downloadable PowerAlert Software and cabling to provide automatic unattended shutdown of connected network and PC applications.
Applications
Tested to CE/IEC 60601-1. UPS provides ultimate safety and reliability for patient point of care solutions, telemedicine, nurse's stations, wireless
communications systems, electronic prescribing applications, medical imaging and mission critical equipment. Not recommended for life support
applications.
Package Includes
SMX700HG Medical Grade UPS System
One USB and One DB9 monitoring cable
Warranty information
Instruction manual
Features
Ideal UPS protection for applications in medical patient-care areas where UL 60601-1 listed medical electrical equipment is required
Built-in isolation transformer with Faraday shield offers full isolation and removes common mode noise while maintaining full AC surge
suppression in all modes
Line-interactive voltage regulation corrects brownouts and overvoltages from 155 to 274 volts back to usable 230V output levels, without
using battery power
Hospital-grade plug and outlets offer added degree of safety and reliability to input/output connections
Full line isolation offers a higher degree of safety and prevents operational problems in sensitive electronic equipment
Resistant to electrostatic discharge

Supports loads up to 700VA/450 watts
36 minutes half load runtime (with 350VA load), 14.5 minutes full load runtime (with 700VA load)
6 protected hospital-grade outlets; IEC C14 inlet on 6-inch dongle
RS-232 and USB monitoring ports for remote monitoring and unattended shutdown
PowerAlert unattended shutdown software available via free download from www.tripplite.com (cabling included)
Complete surge protection, line isolation and EMI/RFI noise filtering
5 diagnostic LEDs indicate AC present, on battery, voltage correction, overload & battery low/replace
Battery replacement door
Grounding lug
Specifications
OUTPUT
Output Volt Amp
Capacity (VA)
700
Output Watt Capacity
(watts)
450
Nominal Output
Voltage(s) Supported
230V
Frequency
compatibility
50/60 Hz (auto-selectable)
Output voltage
regulation (line mode)
-18%, +8%
Built-in UPS output
receptacles
6 C13 outlet(s)
INPUT
Rated input current (at
maximum load)
3.6A
Nominal Input
Voltage(s) Supported
230V AC
UPS input connection
type
C14 inlet
UPS Input cord length
(ft.)
6 inch dongle., 16 gauge
UPS Input cord length
(m)
1.83
Recommended
Electrical Service
10A 230V
Voltage compatibility
(VAC)
230
BATTERY
Full load runtime
(minutes)
14.5 min. (450w)
Half load runtime
(minutes)
36 min. (225w)
DC system voltage
(VDC)
36
Battery recharge rate
(included batteries)
Less than 3.6 hours from 10% to 90%

Replacement battery
cartridge (internal
UPS battery
replacement)
RBC53
Battery Access Battery access door allows hot swap battery replacement without powering connected equipment off
Typical battery
lifespan
3-6 years, depending on usage
VOLTAGE REGULATION
Voltage regulation
description
Line interactive UPS offers 2 boost levels of brownout correction and a single level of overvoltage adjustment to
maintain usable, computer grade output without consuming battery power over an input voltage range of 155 to
274V AC
Overvoltage correction Input voltages between 206 and 245V AC are reduced by 9%
Undervoltage
correction
Input voltages between 183 and 199 are boosted by 10%
Severe undervoltage
correction
Input voltages between 155 and 182 are boosted by 21%
Direct pass through Input voltages between 200 and 244V AC are passed through unchanged
LEDS ALARMS & SWITCHES
LED Indicators 5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status
Alarms 3 function audible alarm indicates power failure conditions (4 short beeps every 10 seconds), overload (continuous
short beeps) and low battery (continuous tone)
Switches Yes, includes 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functions
SURGE / NOISE SUPPRESSION
UPS AC suppression
joule rating
340 joules
EMI / RFI AC noise
suppression
Yes
AC suppression
response time
Instantaneous
PHYSICAL
Installation form
factors supported with
included accessories
Tower
Installation form
factors supported with
optional accessories
Wallmount (UPSWM - tower mounting kit)
UPS / Power Module
dimensions in primary
form factor (height x
width x depth / inches)
12.8 x 7.5 x 9
UPS / Power Module
dimensions in primary
form factor (height x
width x depth / cm)
32.5 x 19 x 22.9
UPS / Power Module
weight (lbs)
42.1
UPS / Power Module
weight (kg)
19.1

UPS Shipping
dimensions (height x
width x depth / inches)
18.5 x 12.2 x 13.4
UPS Shipping
dimensions (height x
width x depth / cm)
47 x 31 x 34
Shipping weight (lbs) 45.4
Shipping weight (kg) 20.4
UPS housing material PVC
Cooling method Cooling via rear-exit cooling fan
ENVIRONMENTAL
Operating
Temperature Range
+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature
Range
+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity 0 to 95%, non-condensing
AC mode BTU / hr.
(full load)
208.6
Battery mode BTU /
hr. (full load)
189.1
COMMUNICATIONS
Communications
interface
USB; DB9 Serial
Software and cabling
included
PowerAlert UPS monitoring software is available via free download from www.tripplite.com for all common network
and standalone operating systems. Ships with 2 cables, 1-USB to USB & 1-DB9 to DB9
LINE / BATTERY TRANSFER
Transfer time 5 milliseconds
Low voltage transfer
to battery power
(setpoint)
155
High voltage transfer
to battery power
(setpoint)
274
SPECIAL FEATURES
Cold Start (startup in
battery mode during a
power failure)
Cold-start operation supported
Appearance Attractive gray tower UPS
CERTIFICATIONS
Certifications Tested to CE/IEC 60601-1, FCC Class B (Emissions)
WARRANTY
Product Warranty
Period (International)
2-year limited warranty
Product Warranty
Period (Mexico)
2-year limited warranty

Product Warranty
Period (Puerto Rico)
2-year limited warranty
More information, including related products, owner's manuals, and additional technical specifications, can be found online at
www.tripplite.com/en/products/model.cfm?txtModelID=4028.
Copyright © 2012 Tripp Lite. All rights reserved. All trademarks are the sole property of their respective owners. Tripp Lite has a policy of continuous
improvement. Specifications are subject to change without notice. Photos may differ slightly from final products.