Triton TDL Gateway Modem Reference guide
TDL GaTeway wireLess MoDeM
insTaLLaTion ProceDures
TDN 07103-10179
May 8, 2012
COPYRIGHT NOTICE
© 2012 Triton. All Rights Reserved. TRITON logo is a
registered trademark of Triton Systems of Delaware LLC.
corPoraTe HeaDquarTers:
21405 B St.
Long Beach, MS 39560
Phone: (800) 259-6672
Fax: (228) 868-9445
TDL GaTeway MoDeM
2
Software Requirement
LOAD SOFTWARE BEFORE PROCEEDING
IF YOU ARE USING TRITON CONNECT, YOU MUST ALSO
UPDATE THE TRITON CONNECT COMPUTER USING TC5.5SP1
AVAILABLE ON THE TRITON PARTNER WEBSITE
Software has been provided on the Triton partner website.
Put the applicable software for your ATM on a USB device.
Follow the instructions on the next page to load all of the software les necessary.
Note step 4 (four) is unique to XScale ATMs (or anytime doing a full load xd le, as
opposed to an update xu le.
PARTS IN KIT 06200-00179
09110-01221 TDL Gateway Modem 1 ea
01270-00010 Antenna 1 ea
09120-07060 USB Communication cable X2 ONLY 1 ea
02051-00069 Double sided tape 1” x 1” square 4 ea
The following parts are to be used on an XScale ATM only. Do not use on X2. Omit
the USB cable used on X2s, it is replaced by the Serial cable and power cable.
09120-00816 Power cable for wireless modem
09120-00313 Serial Communications cable. (green)
Assorted zip ties, 2” Grommet
DOCUMENT UPDATES
October 5, 2011 Original
May 8, 2012 Section 6, added step to ensure DHCP enabled in ATM
The TDL Gateway (WM) is a wireless communications device providing high speed
TCP/IP data transfer. The device is applicable to the following ATMs:
X2 - RL1600, RL2000,RL5000,FT5000,RT2000 (with 10.4” display only)
XScale - RL5000
Traverse
This procedure describes the steps necessary to install the TDL Gateway
Wireless Modem. Software update les are required.
insTaLLaTion
3
Software Installation:
• Check Management > Terminal Status > Conguration Summary > Program
Version.
• If “Program Version” is earlier than 2.4.0, the application will need to be
upgraded using the following instructions, must be completed before proceeding:
1. With USB ash drive inserted, go to Management > Terminal Status > Save
Parameters To External Storage. Press ENTER to continue.
2. Go to Management > System Parameters > Software Update and select load le:
3. System will restart and install software.
4. For XScale only, or any full load (xd), also do the following:
After system boots, login to Management Functions and select “us.tsf” when
prompted for country option. Press ENTER to accept verication screen.
Select “Restore Parameters from External Storage” and select le saved in step 1.
Press ENTER to accept verication screen.
Review optional screen and optional screen button settings in Management >
Terminal Status > Conguration Summary to conrm everything is correct.
Software to Update to 2.4.0 (if Unit is already 2.4.0 proceed to the service packs)
• xd20xcsf2.4.0.tlf - X1 (XScale)
Inside web site le: 2_4_0 US XScale 10_4 color.exe
• xu30xcsf2.4.0.tfv - (X2 8” or 10.4” display)
Inside web site le: 2_4_0 US X2 8 and 10.4.exe
• xu30dcsf2.4.0.tfv - (X2 5.7” display)
Inside web site le: 2_4_0 US X2 5_7.exe
• Traverse - No update required
DO NOT PLUG IN THE MODEM AND START THE ATM UNTIL
ALL SOFTWARE HAS BEEN INSTALLED!
ATM must be at a minimum 2.4.0 with service packs and SSL certicates loaded
Service Pack Installation:
Repeat steps 2 & 3 to load the applicable Service Pack. Service Packs are required.
TDL GaTeway MoDeM
4
NOTE: This second proper restart is required to marry the SSL certicate to the ATM.
Failure to perform this second restart may cause the SSL certicate to be lost if an improper
shut down occurs.
SSL Certicate Load Files (if more than 1 are listed, install both load les):
SSL les are required to allow the ATM to communicate with your host/processor
more securely. Some les are loaded in the updates you just performed. Use the
chart below to determine the additional les required for your ATM.
•Go to Management > System Parameters > Software Update and select load le(s)
from table below to enable SSL for the specied processor, if this has not been installed
previously.
• System will restart and install software.
•After system restarts, go to Management > System Parameters > Restart Terminal again.
Service Packs to load
• xu20xcmn2.4.0sp4a.tlf - X1 (XScale) US Update (must install on US 2.4.0)
Inside web site zip le: XScale_2.4.0_TDL Gateway Modem.exe
• xu30xcmn2.4.0sp4a.tfv - X2 US Update (must install on US 2.4.0)
Inside web site zip le: X2_2.4.0_TDL Gateway Modem.exe
• xu30xcmn3.0.0sp3.tfv - Traverse US Update (must install on US 3.0.0)
Inside web site zip le: X2_3.0.0_TDL Gateway Modem.exe
insTaLLaTion
5
• Go to Management > System Parameters > Shut Down Terminal to shut down. Turn off
power when prompted.
Go to the section for your ATM to continue the hardware installation, and last section
to congure the ATM.
IMPORTANT NOTES:
Use of any antenna, other than that supplied by Triton,
WILL void the RF certication and warranty.
The antenna must be positioned such that there is at least
8 inches (20cm) separation from any person.
Refer to the FCC Certication on the next page.
TDL GaTeway MoDeM
6
Fcc cerTiFicaTion
75$9(56(,167$//$7,21
!# '
1
7'/*$7(:$<02'(0
75$9(56(,167$//$7,21
7'/*$7(:$<02'(0
5/5/,167$//$7,21
!# '
1
7'/*$7(:$<02'(0
5/5/,167$//$7,21
7'/*$7(:$<02'(0
5/,167$//$7,21
!# '
1
7'/*$7(:$<02'(0
5/,167$//$7,21
7'/*$7(:$<02'(0
)757,167$//$7,21
!# '
1
7'/*$7(:$<02'(0
Table of contents
Other Triton Modem manuals
