
3
Step 3
At the back of the Sectional Units that are being joined together,
attach a Rear Bracket (Wide) to join the items using (2) ¼-20 x 1”
Socket Head Screws fitted with (1) ¼” Lock Washer each and (1)
5/16” Flat Washer each through the holes in the bracket into the
threaded holes. Threaded holes are located below the cushion
under sling near the rear of the furniture components. Tighten
screws hand tight.
Align Sectional Units at top of backs, then fully tighten Socket
Head Screws for both wide and narrow brackets with the 3/16”
Hex Key.
Step 4
Repeat Step 2 and Step 3 for each additional Sectional Unit until
all items are fastened together into the desired configuration.
Step 5
Place the seat cushions with velcro down onto each Sectional
Unit. Right and Left Sectional Units have notches in the right or
left of the seat cushion; this notch fits to the frame members.
Place the seat backs onto each furniture component with zippers
down with Velcro attachment straps facing rear. Wrap attachment
straps around cross member bracing on furniture component back
and engage Velcro (2 places).
Note: Back cushions for Right and Left Sectional Units are slightly
tapered and are interchangeable. Back cushion for Armless
Sectional Units have more of a square look.
Align Units at top of Back
4
MORE INFORMATION
For care and cleaning instructions, refer to the Tropitone® Care,
Maintenance, Safety & Warranty Information guide included with
your furniture and available at www.tropitone.com/warranty.
Additional care information, “How To” videos and assembly
instructions for Tropitone Outdoor Furniture and Basta Sole shade
products are also available at our website.
If you have difficulty understanding any of the instructions and
need assistance while assembling your Ravello Crescent
Sectional, please call Tropitone’s Customer Service Center at
949-951-2010.
Tropitone Furniture Co., Inc.
5 Marconi, Irvine, CA 92618
949 951 2010 phone
www.tropitone.com
Part # R9T00504
Revised: 01.23.2013
©2013 Tropitone Furniture Co., Inc.