tropitone Cabana Club 520732 Chaise Lounge Guide

Step 5
Verify the tape is removed. Screws must be installed
underneath the sling. With the Velcro facing up, use the
screws to install the new slings into the bed and headrest of
the chaise. Don’t fully tighten the screws until all 30 screws
are inserted.
Step 6
Confirm the screws are fully tightened.
Re-install the cushion making sure the Velcro is securing the
cushion to the sling. The cushion must be used due to the
Velcro attachment points on the sling.
If you have difficulty understanding any of the instructions
and need assistance while assembling your furniture, please
call Tropitone’s Customer Service Center at 949-951-2010.
Tropitone Furniture Co., Inc.
5 Marconi, Irvine, CA 92618
949 951 2010 phone
www.tropitone.com
Part # R9T00001
Revised: 093008
©2009 Tropitone Furniture Co., Inc.
Cabana Club
520732 Chaise Lounge
Sling Replacement Instructions
Congratulations on the purchase of your Tropitone furniture.
Read through all steps before starting sling replacement.
CAUTION: Do not try to lift or flip components with
only one person. Components may be heavy and
awkward to handle, and may result in injury to
persons or damage to property if not lifted properly.
Tools Required
Philips Screwdriver
Awl or Common Nail
Masking Tape
Safety Glasses
Parts List
Replacement Sling Set (Headrest and Bed pieces)
Shipping Box (retain to use as work surface)

Step 1 Step 3
Prepare a smooth, non-scratch surface (a tarp or pool towels
can be placed on your work surface).
Carefully remove the sling insert bars by pushing the bars
out of the openings.
Remove the cushion from the chaise lounge and place it on
a clean and dry surface.
With two persons, place the chaise on its side as shown
below onto the prepared work surface.
Place the new slings on your prepared work surface with the
Velcro surface up. Carefully install the sling insert bars into
the new slings. Hint: Short, medium and long bars are
inserted into the proper slot on the new slings; the hole
patterns are symmetrical (without top or bottom).
Step 2
Using the Philips screwdriver, remove the sling mounting
screws at 12 places in the headrest and 18 places in the
bed. Place the removed headrest and bed slings flat on your
prepared work surface.
Retain the 30 screws for use in the new sling.
Caution: Be careful not to damage the sling insert bars
(stainless steel) as they will be used to install the new sling.
Warning! Be careful when handling the sling insert bars to
ensure your personal safety. Step 4
Ensure the sling insert bars are fully inserted and not
protruding from either end of the sling. Use masking tape to
secure bars in place so they cannot slip within the sling.
Place the slings on the retained shipping box so the awl can
poke into the box. Warning! Don’t poke into your finger.
Locate the mounting holes in each bar by feel and use the
awl or common nail to punch through both sides of the sling.
The punched holes must be smaller than the ¼” holes in the
sling insert bars.
Holes must be punched
at 12 places in the
headrest and 18 places
in the bed.
Remove the masking tape
being careful not to allow the bars
to slide and misalign the holes.