Trotec BA06 User manual

TRT-BA-BA06-TC2019-40-002-EN
BA06
EN
OPERATING MANUAL
VANE ANEMOMETER

2 EN
vane anemometer BA06
Table of contents
Notes regarding the operating manual.................................2
Safety .....................................................................................2
Information about the device................................................3
Transport and storage...........................................................5
Operation ...............................................................................5
Maintenance and repair ........................................................6
Errors and faults....................................................................6
Disposal .................................................................................6
Notes regarding the operating manual
Symbols
Warning of electrical voltage
This symbol indicates dangers to the life and health of
persons due to electrical voltage.
Warning
This signal word indicates a hazard with an average
risk level which, if not avoided, can result in serious
injury or death.
Caution
This signal word indicates a hazard with a low risk
level which, if not avoided, can result in minor or
moderate injury.
Note
This signal word indicates important information
(e.g. material damage), but does not indicate hazards.
Info
Information marked with this symbol helps you to carry
out your tasks quickly and safely.
Follow the manual
Information marked with this symbol indicates that the
operating manual must be observed.
You can download the current version of the operating manual
and the EU declaration of conformity via the following link:
BA06
https://hub.trotec.com/?id=43621
Safety
Read this manual carefully before starting or using the
device. Always store the manual in the immediate vicinity
of the device or its site of use!
Warning
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/ or serious injury.
Save all warnings and instructions for future
reference.
This appliance can be used by children aged from
8years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
• Do not use the device in potentially explosive rooms.
• Do not use the device in aggressive atmosphere.
• Do not immerse the device in water. Do not allow liquids to
penetrate into the device.
• The device may only be used in dry surroundings and must
not be used in the rain or at a relative humidity exceeding
the operating conditions.
• Protect the device from permanent direct sunlight.
• Do not expose the device to strong vibrations.
• Do not remove any safety signs, stickers or labels from the
device. Keep all safety signs, stickers and labels in legible
condition.
• Do not open the device.
• Observe the storage and operating conditions as given in
the Technical data chapter.

EN 3
vane anemometer BA06
Intended use
Only use the device for measurements of the air velocity within
the measuring range specified in the technical data. Observe
and comply with the technical data.
To use the device for its intended use, only use accessories and
spare parts which have been approved by Trotec.
Improper use
Do not use the device in potentially explosive atmospheres, for
measurements in liquids or at live parts.
Any unauthorised changes, modifications or alterations to the
device are forbidden.
Personnel qualifications
People who use this device must:
• have read and understood the operating manual, especially
the Safety chapter.
Residual risks
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Caution
Keep a sufficient distance from heat sources.
Note
To prevent damages to the device, do not expose it to
extreme temperatures, extreme humidity or moisture.
Note
Do not use abrasive cleaners or solvents to clean the
device.
Information about the device
Device description
By making use of the anemometer air velocities can be
determined in various units:
• metres per second (m/s)
• kilometres per hour (KPH)
• feet per minute (FPM)
• miles per hour (MPH)
• nautical miles per hour in knots (KNT)
Further available for the assessment of the measurements is a
MAX/AVG function (maximum and average value).
The display illumination is automatically activated in poor
lighting conditions.
When not in use, an automatic switch-off saves the battery.
Device depiction
3
4
1
2
7
6
5
No. Designation
1 Vane with sensor
2MAX/AVG button
3 Tripod thread
4 Battery compartment cover
5 Display
6 Light sensor
7 Power button

4 EN
vane anemometer BA06
Display
m/s MPH FPM KNT KPH
MAX AVG
8
11
10
12 9
No. Designation
8MAXindication
9AVGindication (average value)
10 Measurement value indication
11 Indication of the velocity unit
12 Battery status indication
Technical data
Parameter Value
Model BA06
Air velocity
Measuring range 1.10m/s to 30.00m/s
216ft/min to 5900ft/min
3.96km/h to 108.0km/h
2.46mph to 67.0mph
2.13kn to 58.0kn
Accuracy ±3% ±0.30m/s
±3% ±40ft/min
±3% ±1.0km/h
±3% ±0.4mph
±3% ±0.4kn
Measuring range
resolution
0.01m/s
1ft/min
0.1km/h
0.1mph
0.1kn
General technical data
Measuring rate approx. 1measurement per second
Display LCD (monochrome)
Maximum operating
altitude
2000 m
Storage temperature -10°C to 60°C (14°F to 140°F) with
<80%RH
(non-condensing)
Operating
temperature
0°C to 50°C (32°F to 122°F) with
<80%RH
(non-condensing)
Power supply 1 x 9 V battery
Device switch-off after approx. 15minutes of non-use
Weight approx. 158 g (incl. battery)
Dimensions
(Lx Wx H)
167mmx 56mmx 34mm
Scope of delivery
• 1x Device BA06
• 1 x 9V battery
• 1x Bag/ holster
• 1 x Quick guide

EN 5
vane anemometer BA06
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the bag included in the scope of
delivery in order to protect the device from external influences.
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• protected from dust and direct sunlight
• with a cover to protect it from invasive dust if necessary
• The storage temperature is the same as the range given in
the Technical data chapter.
• Remove the battery from the device.
Operation
Inserting the battery
Note
Make sure that the surface of the device is dry and the
device is switched off.
4
13
1. Remove the battery compartment cover(4) from the
device.
2. Use the battery clip(13) to connect the new battery with
correct polarity.
3. Slide the battery compartment cover(4) back on the
device.
Switch-on and measurements
1. Press the power button(7).
ðThe display will be switched on and the device ready for
operation.
2. Hold the sensor(1) into the area where the measurement
is to be performed. Ideally, the vane is aligned precisely to
the flow direction.
ðThe measured value for air velocity will be displayed in
real time.
Note:
Note that moving from a cold area to a warm area can lead to
condensation forming on the device's circuit board. This
physical and unavoidable effect can falsify the measurement. In
this case, the display shows either no measured values or they
are incorrect. Wait a few minutes until the device has become
adjusted to the changed conditions before carrying out a
measurement.

6 EN
vane anemometer BA06
Setting the air velocity unit
1. Press the MAX/AVGbutton(2) for approx. 2seconds.
ðThe indication of the velocity unit(11) switches to the
next unit.
2. Repeat this step until the desired unit is indicated on the
display.
Indication of maximum and average values
1. Briefly press the MAX/AVGbutton(2).
ðThe MAXindication(8) and the measurement's
maximum value will be displayed.
2. Press the MAX/AVG button(2) again to display the average
value.
ðThe AVGindication(9) and the measurement's average
value will be displayed.
3. Press the MAX/AVGbutton(2) again to quit using the
function.
Switching the device off
1. Briefly press the power button(7).
ðThe device will be switched off.
ðThe maximum and average values will be deleted.
Maintenance and repair
Battery change
A battery change is required when the battery status
indication(12) lights up or the device can no longer be switched
on (see chapter Inserting the battery).
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Fault Cause Remedy
The device can no
longer be switched
on.
The battery is dead. Insert a new battery
(see chapter
Operation).
Disposal
The icon with the crossed-out waste bin on waste
electrical or electronic equipment stipulates that this equipment
must not be disposed of with the household waste at the end of
its life. You will find collection points for free return of waste
electrical and electronic equipment in your vicinity. The
addresses can be obtained from your municipality or local
administration. For further return options provided by us please
refer to our website www.trotec24.com.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
In the European Union, batteries and accumulators must not be
treated as domestic waste, but must be disposed of
professionally in accordance with Directive 2006/66/EC of the
European Parliament and of the Council of 6September 2006
on batteries and accumulators. Please dispose of batteries and
accumulators according to the relevant legal requirements.

Trotec GmbH
Grebbener Str. 7
D-52525 Heinsberg
[phone]
[phone]
[email protected]
www.trotec.com