Troy-Bilt TB 672 User manual

IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578) 778-11418
© 2007 24A-672G
Upper Handle
Lower Handle
1
2
3
4
Remove carriage
screws and star
knobs from lower
handle.
Place upper handle over
lower handle.
(A) Raise blower
direction lever to
highest position.
(B) Slide chute
attachment over
blower opening.
(C) Lower blower
direction lever to
middle position to
lock chute.
A
B
C
Star Knobs
Blower
Direction
Lever
Chute
Secure upper handle
to lower handle using
carriage screws and star
knobs removed earlier.

IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2 inch of top of tank.
Need Help?
Call 1-800-800-7310
Move throttle on engine to FAST position.
Fill engine with entire contents of oil bottle.
Use choke lever to choke engine.
Pull starter rope with quick, full arm stroke. If engine
does not start after ten seconds of repeated pulls,
wait a few minutes and repeat this step. When engine
starts, slowly move choke to RUN position.
Gas Cap
Oil Fill
Throttle Control
Choke Control
Recoil Starter
5
6
7
8
9