Troy-Bilt TB154E User manual

IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW
THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT
LEA LA TRADUCCIÓN EN ESPAÑOL EN
EL MANUAL.
Read and understand all instruction, warning and danger labels on the unit.
Need Help?
Call 1-800-828-5500 FLIP OVER FOR
Fast Start Guide
NOTE: Do not plug the extension cord
into the receptacle until the extension
cord is connected to the unit.
Bend the extension cord to form a tight
loop near the cord end. Push the loop
through the bottom hole of the retainer.
3
2
Slide the loop over the retaining clip and
pull down until the cord fits snugly.
4
Clip the switch
cable to the
cable restraints.
Hold the handle bar in the position shown
at left above and slide it onto the lower bars. Align the
holes and insert the bolts as shown at left above, then
screw on the knobs as shown at right above. Make sure
the bail is assembled into the switch assembly.
Bail
Switch Assembly
5Plug the unit into the extension cord then
the extension cord into a grounded outlet.
NO ASSEMBLY TOOLS REQUIRED
1

Read and understand all instruction, warning and danger labels on the unit.
IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW
THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT
LEA LA TRADUCCIÓN EN ESPAÑOL EN
EL MANUAL.
778-12348 P00
Operating
Position
9
Release the (red) starter button and grasp the handle and bail together with both
hands.
NOTE: The cultivator's motor will NOT start if you fail to hold the starter button in
while pivoting the bail upward.
8
7Pivot the cultivator slightly toward the rear so that its weight is resting on the wheels
and the tines are NOT in contact with the ground.
Depress the (red) starter button and hold it in (1 above). While holding the starter
button in, pivot the bail (2 above) upward against the handle bar to start the motor
and engage the tines.
NOTE: Starting the cultivator's motor also starts tilling action.
6Stand in the operating position.
Need Help?
Call 1-800-828-5500