Truma Multivent TBM User manual

Operating instructions Page 2
To be kept in the vehicle!
Multivent TBM
Multivent

2
Multivent fan TBM – Two-stage 12 V universal fan
Safety instructions
For safe and proper use, carefully read, follow
and keep for later use the operating instruc-
tions and other documents that are supplied
with the product. The respective valid laws,
directives and standards must be observed.
Not following the rules in the operating and
installation instructions can result in serious
material damage and serious risk to the health
or life of persons. The appliance’s operator or
user is solely responsible for such damage.
Only competent and trained persons
(experts) may install, repair or perform
the function check on the Truma product in
accordance with the installation and operat-
ing instructions and the currently accepted
technical regulations. Experts are persons
who, based on their specialist instruction and
training, their knowledge and experience with
Truma products and the relevant standards,
can carry out the necessary work properly and
identify potential hazards.
Symbols used
Symbol indicates possible hazards.
Note containing information and tips.
Intended use
The Multivent fan TBM is used as an extractor fan (FigureA)
in kitchens or WCs, and also to increase the air capacity in
existing warm air systems (Figure B).

3
Operating instructions
Control panel
Multivent
a
b
c
a = Off
b = half setting
c = full setting
Start-up
Switch to the required power (b or c) on the control panel.
Switching off
Switch off at the control panel (a).
Technical data
(determined in accordance with EN 624 or Truma test conditions)
Dimensions in mm
150 x 130 x 124 (L x W x H)
Operating voltage
12 V direct voltage
Power consumption
Half setting 0.23 A / full setting 0.5 A
Air flow rate
Half setting 29 m³/h / full setting 60 m³/h
Subject to technical changes.
This appliance may be used by children from
8years old and by persons with reduced phys-
ical, sensory or mental capabilities or with a
lack of experience and knowledge only if they
are supervised or have been instructed in the
safe use of the appliance and understand the
resulting risks. Children must not be allowed
to play with the appliance.
Disconnect the fan from the power supply at
all poles before carrying out maintenance or
repair work!
Do not put a faulty or damaged fan into op-
eration. Have the fan repaired or replaced by
experts.

4
Manufacturer’s Warranty
(European Union)
1. Scope of Manufacturer’s Warranty
As the Manufacturer of the appliance, Truma undertakes a
warranty towards the Consumer that covers any material and/
or manufacturing defects of the appliance.
This Warranty is applicable in EU member states as well as
in Iceland, Norway, Switzerland and Turkey. A Consumer is
the natural person who was the first one to purchase the
appliance from the Manufacturer, OEM or dealer and who
neither resold the appliance in a commercial or self-employed
professional capacity nor installed it for a third party in such a
capacity.
The Manufacturer’s Warranty covers any of the aforemen-
tioned defects that occur within 24 months upon concluding
the purchase agreement between the seller and the Con-
sumer. The Manufacturer or an authorised service partner
undertakes to remedy such defects through subsequent fulfil-
ment, i.e. at its discretion either by repairing or replacing the
defective item. Any defective parts shall become the property
of the Manufacturer or the authorised service partner. If the
appliance is no longer manufactured at the time of defect no-
tification and if replacement delivery has been opted for, then
the Manufacturer may deliver a similar product.
If the Manufacturer remedies a defect under its warranty
commitment, the term of the Warranty shall not start again
with regard to the repaired or replaced parts; rather, the orig-
inal warranty period shall continue to be applicable to the
appliance. Only the Manufacturer itself and an authorised ser-
vice partner shall be entitled to conduct a warranty job. Any
costs that occur in the event of a warranty claim shall be set-
tled directly between the authorised service partner and the
Manufacturer. The Warranty does not cover additional costs
arising from complicated removal or installation jobs on the
appliance (e.g. dismantling of furnishings or parts of the vehi-
cle body), and neither does it cover travel expenses incurred
by the authorised service partner or the Manufacturer.
No further-reaching claims shall be permitted, especially dam-
age claims presented by the Consumer or third parties. This
provision shall not affect the validity of the German Product
Liability Act (Produkthaftungsgesetz).
The voluntary manufacturer’s warranty does not affect the
consumer’s legally valid claims for defects against the seller in
the relevant country of purchase. In individual countries there
may be warranties that can be issued by the relevant dealer
(official distributor, Truma Partner). In such cases the warranty
can be implemented directly through the dealer from whom
the Consumer bought the appliance. The warranty regulations
of the country in which the appliance was purchased by the
Consumer for the first time shall also be applicable.
2. Warranty exclusions
No warranty claim shall be applicable under the following
circumstances:
– Improper, unsuitable, faulty or negligent use and any use
that is not compliant with the intended purpose
Disposal
The appliance must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-Life Vehicle Regulation) must be observed.

5
– Improper installation, assembly or commissioning, contrary
to operating or installation instructions
– Improper operation or operation contrary to operating or
installation instructions, particularly any disregard for main-
tenance, care or warning notes,
– Instances where installations, repairs or any other proce-
dures have been conducted by non-authorised parties
– Consumable materials and parts which are subject to natu-
ral wear and tear
– Installation of replacement, supplementary or accessory
parts that are not original manufacturer’s parts or which
have not been approved by the manufacturer. This applies
in particular if the appliance is subject to networked control,
if the control units or the software have not been approved
by Truma or if the Truma control unit (e.g. Truma CP plus
or Truma iNet Box) has not been exclusively used for con-
trolling Truma appliances or appliances approved by Truma.
– As a consequence of damage arising from foreign sub-
stances (e.g. oil, or plasticisers in the gas), chemical or
electrochemical influences in the water, or cases when the
appliance has come into contact with unsuitable sub-
stances (e.g. chemical products, flammable substances or
unsuitable cleaning agents)
– Damage caused by abnormal environmental or unsuitable
operating conditions
– Damage caused by force majeure or natural disasters or
any other influences not within Truma’s responsibility
– Damage resulting from improper transport
– End customer’s or third-party modifications of the appli-
ance, including any replacement, supplementary or acces-
sory parts, or installation of the same, especially concerning
the exhaust gas system or the cowl.
3. Making a warranty claim
The warranty must be claimed with an authorised service part-
ner or at the Truma Service Centre. All the relevant addresses
and phone numbers can be found at www.truma.com, in the
“Service” section.
The Manufacturer’s address is:
Truma Gerätetechnik GmbH & Co. KG
Truma Servicezentrum
Wernher-von-Braun-Straße 12
85640 Putzbrunn, Germany
To ensure a smooth procedure, we would be grateful if you
could have the following details ready before contacting us:
– Detailed description of the defect
– Serial number of the appliance
– Date of purchase
The authorised service partner or the Truma Service Centre
will then specify the further procedure. To avoid transport
damage, the affected appliance must only be shipped by prior
arrangement with the authorised service partner or the Truma
Service Centre.
If the warranty claim is recognised by the Manufacturer, then
the transport expenses shall be borne by the same. If no
warranty claim is applicable, the Consumer will be notified
accordingly and any repair and transport expenses shall then
be the Consumer’s liability. We ask you not to send in an ap-
pliance without prior arrangement.

Truma Gerätetechnik GmbH & Co. KG
Wernher-von-Braun-Straße 12
85640 Putzbrunn
Deutschland
Service
Telefon [phone]
Telefax [phone]
[email protected]
www.truma.com
39030-23200 · 03 · 04/2018 ·
Should problems occur, please contact the Truma Service
Centre or one of our authorised service partners
(see www.truma.com).
In order to avoid delays, please have the unit model and serial
number ready (see type plate).
©