TUHOME Furniture Kava BLB 6551 User manual

KAVA BAR CABINET
Mueble Bar Kava
Alto: 180,6 cm
Ancho: 51 cm
Fondo: 34 cm
Height: 71,10 in
Width: 20,08 in
Depth: 13,39 in
LOT N°
ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE ENSAMBLEFURNITURE
IF ANY PARTS ARE BROKEN OR
MISSING PLEASE CONTACT US
AT: 1-888-391-01-66 /
customerservicetuho[email protected]m.co
OUR CUSTOMER SERVICE TEAM WILL PROVIDE
YOU HELP TO RESOLVE ANY ISSUES IMMEDIATELY

!
WARNING
!
Page 2
IMPORTANT
RECOMMENDATIONS RECOMENDACIONES IMPORTANTES
No pintar el mueble.
El mueble debe ser usado únicamente en interiores,
no exponer al sol directo.
Limpiar los herrajes metálicos con un paño seco.
NO sobrecargar el mueble (ver las cargas sugeridas).
No golpear ni martillar el mueble (solo cuando se
indique).
Limpiar con un paño ligeramente húmedo,
usar jabones suaves.
No arrastre el mueble, levántelo entre dos personas.
Evite el contacto directo con el agua, el fuego o la
exposición a fuentes de calor.
Do not paint the cabinet.
The cabinet MUST be used exclusively indoors,
do not expose to direct sun.
Clean metallic hardware with a dry cloth.
Do NOT overload the cabinet (see suggested loads).
Do not hit or hammer the cabinet (just when
indicated).
Clean with a slightly damp cloth, use gentle soaps.
Do not drag, lift and move between two people.
Avoid direct contact with water, fire or exposure
to heat sources.
Never allow children to climb or manipulate
the cabinet, furniture tip over can cause
serious injuries or death.
ADVERTENCIA
!
Nunca permita que los niños escalen o
manipulen el mueble, la caída de este
puede provocar lesiones graves o la muerte.
FURNITURE

REQUIRED TOOLS* HERRAMIENTAS NECESARIAS*
Page 3
*Not included, and not shown actual size. *No incluidas y no se muestran en tamaño real.
INDEX ÍNDICE
Assembly Hardware
Assembly Parts
Suggested Loads
Assembly Recommendations
Assembly Steps
Warranty
4
5
6
6
7-19
20
Herrajes para Armado
Piezas de Armado
Cargas Sugeridas
Recomendaciones de Ensamble
Pasos de Armado
Garantía
4
5
6
6
7-19
20

ASSEMBLY HARDWARE HERRAJES PARA ARMADO
Page 4
Please check that the hardware content is correct.
If any item is missing, please call to our customer
service line.
Hardware items are NOT shown actual size. Los herrajes no se muestran en el tamaño real.
Compruebe que el contenido de los herrajes sea
el correcto. En caso de que falte alguna pieza, por
favor llame a nuestra línea de atención al cliente.
x19
Minifix Cams
Minifix
Spreading Bolt
Perno Minifix
x19x64
Wood Dowel
Tarugo
Cover Caps
Tapa Adhesiva
Minifix
x30
x4
Nail-on Glide
Deslizador Puntilla
x10
2" Drywall Screw
Tornillo de
Ensamble2"
x2
Handle
(Screws Included)
Manija
(Incluye Tornillos)
Inset Hinge
(Screws Included)
Bisagra Interior
(Incluye Tornillos)
x4 x1
Drawer Slides
(Screws Included)
Rieles
(Incluye Tornillos)
Shelf support
Soporte Entrepaño
x1 x2
Wall Fixing Kit
(Screws Included)
Kit Anti vuelco
(Incluye Tornillos)
x2
H profile
Perfil en H

ASSEMBLY PARTS PIEZAS DE ARMADO
Page 5
A - x1
B - x1
C - x1
D - x1
E - x1
EI - x1
F - x1
G - x3
H - x3
I - x2
J - x1
K - x5
L - x5
M - x2
N - x2
O - x1
PI - x1
PD - x1
A
K
L
E
G
EI
M
F
N
C
I
D
B
PD
PI
M
O
N
I
H
J
G
G
L
L
L
L
KKKK
H
H

MAX SUGGESTED LOADS CARGAS MÁXIMAS SUGERIDAS
ASSEMBLY
RECOMMENDATIONS RECOMENDACIONES DE ENSAMBLE
Page 6
Two people are recommended to assemble
the product.
Assemble the cabinet on a flat, smooth
surface, preferably on a carpeted floor
or the carton box of the product.
Carefully read the assembly instructions
and identify every wood and hardware
part before start assemblying the cabinet.
Ensamble el mueble entre dos personas.
Ensamble el mueble sobre una superficie
plana y lisa, preferiblemente sobre un
tapete o el cartón de la caja
Lea cuidadosamente las instrucciones e
identifique todas las piezas y herrajes
antes de empezar a armar el mueble.
10kg
10kg
20kg
8kg
22lb
22lb
44lb
18lb

1
Page 7
2
x2
A
D
x4
x2
Arrow

Page 8
3
4Turn Over
Voltear
B
B
x4
x2
4
!

Page 9
5
6
x2
C
C
Arrow
Turn Over
Voltear
4
!

Page 10
7
8
E
x2
EI
F

Page 11
9
10
Gx3
J
Ix2 x2

Page 12
11
12
Kx5
Lx5
x5
K
LTurn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
Gently hit the pieces
to adjust the joint.
Golpee suavemente las
piezas para ajustar
el ensamble.

Page 13
13
14
Ax10
K
K
K
K
K
L
L
L
L
L
D
I
I
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
x4

Page 14
15
16 Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas. x4
E
EI
G
GG
JEG
G
GEI
F
B
I
I
D
Gently hit the pieces
to adjust the joint.
Golpee suavemente la
pieza para ajustar
el ensamble.

Page 15
17
18
N
G
G
G
B
J
IDI
EI
F
IDI
N
N
F
B
EI
G
G
G
J
C
x4
N
N
N
1.
2.
Slide the H profile of
33,3" between
the back panels.
Deslice el perfil en H de
84,7 cm entre los
fondos.

Page 16
19
20
M
MC
J
EI
G
G
G
B
F
IDI
F
D
I
I
C
B
N
M
G
G
G
J
EI
A
L
L
L
L
L
x2
Slide the H profile of
32,8" between
the back panels.
Deslice el perfil en H de
83,4 cm entre los
fondos.
M
M
1.
2.
Slide the H profile of
32,8" between
the back panels.
Deslice el perfil en H de
83,4 cm entre los
fondos.

Page 17
21
22
x4
PI
PD
O

Page 18
23 Door Installation
Instalación de las Puertas
Side adjustment
Ajuste lateral
Depht adjustment
Ajuste de profundidad
Height adjustment
Ajuste de altura
Hinge adjustment
Ajuste de las bisagras
45
2 3
x16
1
PI
PD
D
F
OC
H
H
H
E
BJ
A

24
Page 19
!
For the user safety, it is recommended
to anchor the furniture to the wall.
Por la seguridad del usuario se recomienda
anclar el mueble a la pared.
After you finish the adjustment
of the cams, cover them with
the cover caps.
Después de ajustar todas las
cajas minifix, cúbralas con las
tapas adhesivas.
After you finish assembling the
cabinet, take off the adhesive
letters.
Al terminar de armar, desprenda
las letras adhesivas.
A
-WARNING! TIPPING HAZARD – Unanchored
furniture can tip over
-WARNING: CHECK FOR HIDDEN PIPES AND
CABLES BEFORE DRILLING.
-IMPORTANT: IF YOUR WALLS ARE NOT SOLID
LIKE BRICK OR STONE, YOU WILL REQUIRE
SPECIALIST FITTINGS (NOT SUPPLIED)
-Pre-drill small pilot hole on the back edge of the
furniture top using a 2mm drill bit. Attach the other
end of the fixing strip to the back edge of the
furniture top using the 15mm screw + washer and
securely tighten.
-Place fixing strip against the wall and mark position
for drilling hole.
-Drill hole in your wall to a depth of 30mm using a
6mm drill bit. If the surface of your wall is soft and
crumbly, we would advise you to use a 5mm drill bit
for a tighter fit.
-Insert plug into hole with end flush to the wall
surface.
-Attach fixing strip to the wall using the 25mm
screw + washer and securely tighten.
-¡ADVERTENCIA! PELIGRO DE VOLCAMIENTO -
Los muebles no anclados a la pared pueden
volcarse.
-¡ADVERTENCIA! Compruebe que no haya tubos o
cables ocultos antes de perforar la pared.
-¡ADVERTENCIA!: Si sus paredes no son sólidas
como ladrillo o concreto, necesitará anclaje
especial ( no suministrado).
-Pre-taladre un pequeño orificio piloto en el borde
posterior de la parte superior del mueble con una
broca de 2mm. Fije el otro extremo de la tira de
fijación al borde posterior del mueble con el tornillo
de 15mm + arandela y apriete firmemente.
-Coloque la tira de fijación contra la pared y marque
la posición para perforar.
-Haga un agujero en la pared a una profundidad de
30mm con una broca de 6mm. Si la superficie de su
pared es suave y desmoronadiza, le recomendamos
que use una broca de 5mm para un ajuste más
apretado.
-Inserte el chazo plástico en el orificio con el
extremo al ras de la superficie de la pared.
-Fije la tira de fijación a la pared con el tornillo de
25mm + arandela y apriete firmemente.

Page 20
WARRANTY POLICY
PÓLIZA DE GARANTÍA
TUHOME Furniture has a 3 year warranty coverage in wooden parts and 1 year warranty
coverage in hardware pieces since its manufacturing date, which you can see in the lot
number printed on the product box and the assembly instructions leaflet.
Warranty covers materials and workmanship imperfections which impair the assembly
or correct functioning of the cabinet.
This warranty is not valid if the defects or imperfections are caused by the incorrect
following of the assembly instructions, warnings and recommendations, misuse,
intentional damage, fire or flood, or after modifications or any kind of alteration, or
repaired by someone not authorized by TUHOME Furniture, when it´s been assembled 3
months after the date of purchase. These defects MUST be reported before the warranty
coverage period ends. Once the product has been assembled, the company will not be
responsible for defective and/or damaged parts.
This warranty is ONLY valid for the ORIGINAL PURCHASER, it doesn’t apply if the
product has been resold, rented, etc.
TUHOME Furniture will take no liability for incidental or consequential damages caused
to or by the product (This may not apply in your state).
To make this warranty valid you must write to our customer service email describing the
product defect, lot number and submitting your sales reciept or proof of purchase, or
contact us at our customer service line. Replaced parts will be under the product´s
original warranty coverage period. Damaged parts will become property of the
company.
There are no other warranties applicable to this product.
FURNITURE
IF ANY PARTS ARE BROKEN OR
MISSING PLEASE CONTACT US
AT: 1-888-391-01-66 /
customerservicetuho[email protected]m.co
OUR CUSTOMER SERVICE TEAM WILL PROVIDE
YOU HELP TO RESOLVE ANY ISSUES IMMEDIATELY