TW Audio M10 User manual

Operation manual M10

Operation manual M10
2
Introduction
The M10 combines the advantages of the compact M8 with the imposing qualities of the high
performance M12. The M10 is fitted with the same 1.4“ mid-high driver as the M12 and the
M15, enabling a deep crossover frequency, thus giving a sound with the best possible intelli-
gibility and directness. Something that you do not get every day within this class. The low-mid
range is served by a 10“ driver with an extended voice coil for extra large linear excursion.
As a full range speaker, a compact monitor or a top, for instance in actively crossed over
combination with a B18 or B30 subwoofer, the M10 offers a direct sound with plenty in
reserve. Almost invisible. But impressively audible.
Instructions in this user manual
NOTE
CAUTION
WARNING
WARNING
Thank you for choosing a high-quality product “MADE IN GERMANY” from the brand
TW AUDiO.
If you lend your product to another party, inform that party of the safety-related operating pro-
cedures and hand over this assembly guide. If you require additional copies of this manual,
you can obtain them free of charge from TWAUDiO or download them from www.twaudio.de
Strictly adhere to the instructions contained in this operating manual that are marked as
follows:
This symbol in combination with the signal word “Warning” identifies a potentially hazardous
situation. Failure to comply with this safety instruction can lead to serious injury or even death.
This symbol in combination with the signal word “Warning” identifies a potentially hazardous
situation for persons with a pacemaker. Failure to comply with this safety instruction can lead
to serious injury or even death.
This symbol in combination with the signal word “Caution” identifies a potentially hazardous
situation. Failure to comply with this safety instruction can lead to light or moderate injury.
This symbol in combination with the signal word “Note” identifies a potentially hazardous
situation. Failure to comply with this safety instruction can lead to product damage.

Operation manual M10
3
TIP
Notes on the products
Read manual
before use!
Before using the device, carefully read the operating manual and keep it with the M10 loudspe-
aker.
General information
Operation manual: OM-M10
Version 2.0 en, 02/2022
This symbol in combination with the signal word “Tip” identifies additional information or
notes that will simplify working with TWAUDiO products on the basis of practical experience.
© by TWAMBO 2022; all rights reserved.
All information contained in this operating manual was correct to the best of our knowledge
at the time of printing.
Quality warranties or assurance of suitability for a certain type of use based on the technical
specifications, dimensions and weights are not granted by TWAMBO.
TWAMBO also shall not assume liability for any secondary damage (property damage and/or
personal injury) nor for the failure to comply with this operating manual!
TWAMBO reserves the right to update this document based on recent developments.
TWAMBO GmbH
Karl-Hofer-Str. 42
14163 Berlin
Germany
Phone : + 49 (0) 71 41-48 89 89 0
Fax: + 49 (0) 71 41-48 89 89 99
E-Mail: [email protected]
WWW: www.twaudio.de

Operation manual M10
4
Content
1. Safety | Intended use...................................................................................................... 5
2. Overview ........................................................................................................................ 7
2.1 Components ........................................................................................................... 7
2.2 Variants ................................................................................................................... 8
3. Technical specifications .................................................................................................. 9
3.1 Data sheet............................................................................................................... 9
3.2 Connection diagram ................................................................................................ 9
4. Commissioning............................................................................................................. 10
4.1 Setup .................................................................................................................... 10
4.2 Rotating the HF horn ............................................................................................. 11
4.3 Operation .............................................................................................................. 12
4.4 Connecting the cable............................................................................................. 12
5. Transport and Storage.................................................................................................. 13
6. CE Conformity Declaration............................................................................................ 14
7. Disposal ....................................................................................................................... 15

Operation manual M10
5
1. Safety | Intended use
The M10 loudspeaker was developed for use in professional sound systems. The loudspea-
ker may only be used by trained and qualified personnel.
WARNING
WARNING
WARNING
NOTE
NOTE
Please adhere to the following safety instructions to avoid risks when operating loudspeakers.
Note the operating modes described in this operating manual. Other uses are not permis-
sible.
Damage caused by improper use is not covered by TWAMBO.
Loudspeakers generate an electromagnetic field. Persons with pacemakers are not permit-
ted to remain in the immediate vicinity of loudspeakers as the electromagnetic fields can
cause pacemakers to malfunction.
When setting up loudspeakers, ensure that they are not exposed to the following ambient
conditions:
• Direct sunlight
• Humidity
• Jolting
• Dust
Keep away from the immediate vicinity of loudspeakers that are operated at high sound pres-
sure levels. These loudspeaker systems are capable of endangering your health. Sound levels
beginning as low as approximately 90dBSPL can lead to long-term hearing impairment.
Avoid:
• Feedback
• Distorted signals (clipping) and
• Peaks resulting from switching on devices, plugging in devices or unplugging devices during
operation.
Such signals can lead to loudspeaker overload and ultimately to loudspeaker failure.
Ensure that the units are in a stable position and are firmly attached. A falling loudspeaker can
result in serious personal injury and property damage.
When using and assembling TW AUDiO loudspeakers, only use materials specified by
TW AUDiO. These tasks must be performed by qualified personnel. Adhere to the applicable
safety regulations.

Operation manual M10
6
WARNING
NOTE
NOTE
Ensure that the loudspeaker is not exposed to permanent thermal overloads. Thermal over-
loads may cause a fire and result in serious personal injury and property damage.
Note that TWAMBO does not provide a warranty for damage that can be attributed to this type
of overload and therefore cannot be held liable for any secondary damage.
A permanent magnetic field is present in the immediate vicinity of loudspeakers. Ensure that
objects which react sensitively to magnetic fields are not located in the immediate vicinity of
the loudspeaker. In particular, this applies to magnetic storage media, magnetic stripe cards
such as debit cards and CRT displays. A distance of approximately one meter is sufficient to
avoid damage.
Check loudspeakers and accessory parts regularly for visible wear. This is essential to ensure
continuing fault-free operation. Worn parts should be replaced immediately. Spare parts are
available from TWAUDiO.

Operation manual M10
7
2. Overview
2.1 Components
1. 15 mm multiplex enclosure - Warnex surface finish
2. Ergonomic carrying handles (top and bottom)
3. Top rigging track
4. Connection panels one SpeakON® connector each at the top and bottom and
two connectors on the back
5. Rotable horn with 1.4“ compression driver
6. 10“ cone driver
7. Rubber feet (4 pieces each)
8. Type label
9. Rear rigging track
10. Bottom rigging track with integrated cabinet flange
Figure 2.1 - Overview
1 2 34
5
6
10
4
9
9
7
8
4

Operation manual M10
8
2.2 Variants
The M10 loudspeaker is available in right and left variants. These versions differ in the side on
which the slanted wedge is located on the enclosure.
Figure 2.2 - Left and right versions
1,4“ compression driver
left version right version

Operation manual M10
9
3. Technical specifications
3.1 Data sheet
Drivers 1x 10“ LF / 1x 1.4“ HF
Frequency response 68 - 19000 Hz
Power handling (program/Peak) 600 / 1200 W
Impedance 8 Ω LF
Coverage angles (h x v) 75° x 50°
Max. SPL / 1m 127 dB
Dimensions (h x w x d) 505 x 300 x 280 mm [19,88 x 11,81x 11,02 in]
Weight 15,2 kg [33.5 lbs]
Surface Warnex textured paint
3.2 Connection diagram
Figure 3.2 - Connection diagram
HF 1,4"
LF 10"
PASSIVE
X-OVER 8 OHM
8 OHM
1,3 kHz
PIN 1+
PIN 1-
PIN 2+
PIN 2-
8 OHM
PIN 1+
PIN 1-
PIN 2+
PIN 2-
PIN 1+
PIN 1-
PIN 2+
PIN 2-
PIN 1+
PIN 1-
PIN 2+
PIN 2-

Operation manual M10
10
4.1 Setup
The M10 loudspeaker is designed for standing, vertical and horizontal operation. TWAUDiO
provides a wide range of accessories to securely attach the loudspeaker.
NOTE
WARNING
4. Commissioning
WARNING
Make sure that all system structures are located on a firm, level surface and that the surface
can bear the total weight!
TW AUDiO recommends using only the accessories specified by TWAUDiO for securing and
mounting loudspeakers.
Make sure the speakers are securely fastened to prevent personal injury and property damage.

Operation manual M10
11
4.2 Rotating the HF horn
The horn of the M10 loudspeaker is positioned such that the horizontal coverage is 75° and
the vertical coverage is 50°. In some situations, it may be advantageous to switch the cover-
age of the high-frequency range. To do this, you can rotate the horn of the M10 loudspeaker.
Proceed as follows.
1. Place the M10 loudspeaker with the wedge inclined toward you with the grill facing up.
Ensure that the working surface is clean with a non-slip finish.
2. To remove the front grill of the loudspeaker, use a 3mm hex key. Remove the four screws
on the top and bottom of the loudspeaker enclosure (two on each side).
3. Release the four screws of the horn using a 5 mm hex key.
4. Pull the horn upward out of the loudspeaker enclosure.
5. Check that the seal between the enclosure and horn is properly seated.
6. Rotate the horn carefully by 90° and reinsert the horn and driver back into the recess.
Screw it onto the enclosure using medium-strength thread locker.
7. Screw the front grill back on hand-tight.

Operation manual M10
12
4.4 Connecting the cable
The pin connections of the M10 loudspeaker can be found in section 3.2 (“Connectiondia-
gram”) on page 9.
The internal wiring of the M10 loudspeaker allows for parallel connection of multiple loudspe-
aker units.
NOTE
4.3 Operation
TW AUDiO recommends operating the M10 loudspeaker on a DSP controller. For this pur-
pose, only presets developed by TWAUDiO are recommended. The TWAUDiO system racks
are ideally suited for this purpose.
Please note the technical data in section 3.1 on page 9.
NOTE
NOTE
Before connecting the loudspeaker to the amplifier, ensure that the right preset has been
loaded.
Using a wrong, out dated or a preset not provided by TWAUDiO can lead to destruction of
the speaker.
Make sure that the amplifier’s specifications meet the requirements. Using an amplifier that
doesn’t meet the specifications can destroy the loudspeaker.
To create a cable connection with an amplifier rack from TWAUDiO, proceed as follows.
Ensure that the cable cross sectional area is sufficient (at least 1.5 mm²) to avoid power losses.
TW AUDiO recommends using the loudspeaker cables available from TWAUDiO.
When connecting the cables to the loudspeaker, ensure that polarity (+/-) and pin assignment
(1/2) are correct. Incorrect connection can lead to a significant change in the loudspeaker’s
sound characteristics and may damage the driver.
Please note that parallel connections will decrease the total impedance of your loudspeaker
configuration.
The total impedance and the resulting power of the speaker configuration must match the
output power of the amplifier.

Operation manual M10
13
5. Transport and Storage
NOTE
To enable a single person to transport two M10 loudspeakers, TWAUDiO recommends
using the CaseM10.
• CoverM10 (protective cover for one M10)
• CaseM10 (flightcase for two M10)
When transporting and storing the unit, it is important to ensure that the surface and front
grill of the loudspeaker are not damaged. Moisture can penetrate through exposed wood
surfaces and cause the wood to swell. A bent or broken front grill will no longer adequately
protect the sensitive speaker membranes.
In addition, appreciable dust deposits may considerably impair the functionality of a loudspe-
aker membrane. For this reason, the loudspeakers should be transported and stored in a
safe, careful, dry and largely dust-free manner.
The following accessory parts for transport and storage are available from TW AUDiO:
The original packaging is unsuitable as permanent storage and transport packaging.

Operation manual M10
14
as well as all model variants based on these, provided that they correspond to the original
factory models and have not been technically modified in any way.
Applicable directives:
• 2001/95/EG
• 2011/65/EU
Applicable national standards and technical specifications:
• DIN EN 18 800
• DIN EN ISO 12 100
• DGUV Vorschrift 17 und 18
• EN 50581: 2013-02
Berlin, Germany, January 1st, 2021
Bernhard Wüstner
5
This declaration applies to the following components
• M10 L
• M10 R
6. CE Conformity Declaration
Copy and translation of the original CE Conformity Declaration:
We hereby declare that the below-referenced components by virtue of their design and
construction, and in the configuration placed on the market by us, satisfy the safety and
health requirements of the applicable EC directives. This declaration becomes invalid in
case of modifications that have not been approved by us.

Operation manual M10
15
7. Disposal
It is prohibited to dispose of used electrical equipment with household refuse.
All TWAMBOGmbH products are so-called B2B-products. This means that they are sold by
a commercial business to a commercial business. TWAMBO products that bear the trash can
symbol shown here may only be disposed of by TWAMBO.
The loudspeaker owner is legally responsible for proper disposal of used devices that do not
bear this symbol. This pertains to all products delivered prior to March 29, 2010. Nevertheless,
TWAMBO will also be happy to assist you in this case.
If you have any question regarding the disposal of used devices, please contact us under the
following telephone number:
+49 (0) 71 41 - 48 89 89 0
Thus, TWAMBO is in strict compliance with the Waste Electrical and Electronic Equipment
Directive (2012/19/EU) for the protection of our environment.
TWAMBO is registered under the following WEEE-reg.-no. with the German National Register
EAR as a B2B-manufacturer and distributor of electrical devices:
DE93295191
In countries outside of the European Union, comply with local regulations.

Operation manual M10
16
TWAMBO GmbH
Karl-Hofer-Str. 42
14163 Berlin
Germany
Phone: + 49 (0) 71 41-48 89 89 0
Fax: + 49 (0) 71 41-48 89 89 99
E-Mail: [email protected]
WWW: www.twaudio.de