Twin Eagles TEGB36-B User manual

P/N: 18542C 03/08
TWIN EAGLES GRILL BASE
BASE ASSEMBLY &
GRILL HEAD INSTALLATION
Model: TEGB30-B
TEGB30SD-B
TEGB36-B
TEGB36SD-B
TEGB42SD-B
TEGB30SD-B Grill Base shown.

1
ASSEMBLY INSTRUCTIONS –TWIN EAGLES GRILL BASE
1. Install casters w/ brakes (A) at the front of the
base and casters w/ out brakes (B) at the
rear and secure them with nuts (C).
2. Install shelf brackets (D) and (E) securing them
with screws (F) and side shelves.
3. Remove hex-head screws (G) and flat-
washer (H) using a 5/16” wrench and place
the grill head into the cart.
4. Install the hex-head screws (G) with flat-washer
(H) back into place by initially hand tightening
them. Then use the 5/16” wrench to tighten the
screws completely.
5. Fasten the BBQ grill at the top-rear corners using
the Philip screws (I), reference picture no.2.
(A) Caster w/ brake
(Qty. 2)
(B) Caster (Qty. 2)
(D) Shelf Bracket
(LEFT) (Qty. 2)
(E) Shelf Bracket
(RIGHT) (Qty. 2)
(G) Hex-head Philips
screw (pre-installed w/
washers) (Qty. 2)
(I) 10-32 x ½”
Phillips Screw
(Qty. 2)
(C) ¼”-20 hex nut (Qty. 16)
(F) Flat head screws (Qty. 8)
(H) Flat-washer
(pre-installed w/
hex-screw) (Qty. 2)
(D)
(E)
(F) ( I )
( I )
(B)
(C)
(A)
(G)
(G) (H)
(H)

2
ADDITIONAL INSTRUCTIONS –TWIN EAGLES GRILL BASE
TO SECURE POWER TRANSFORMER
All grill models with interior lights have a power
transformer which is concealed in a stainless steel box
with an attached power supply cord. This transformer
must be secured in a dry location and away from
excessive heat.
1. In a base cart application, 2 mounting screws with
nuts are provided at the bottom-right-rear corner of
the cart. If not provided, drill 2 holes using the
transformer box as a template. Secure the
transformer box as shown.
2. Plug-in the transformer’s power cord to the
properly grounded GFCI 120V outlet.
3. Connect the transformer harness to the harness
located at back of the grill.
SIDE SHELF
Side shelf UP (User position): Hold the side shelf from the end, flip it up and push the side shelf down
at the bracket area. Be sure that the side shelf has lock down before
placing items on the shelf.
Side shelf DOWN (Non-users position): Hold the side shelf from the sides around the bracket area, pull
it up and then flip it down.