tws A3 User manual

TWS A3 WIRELESS
EARPHONES WITH TOUCH
SENSOR

1
Wireless pairing
Open the charging case, remove the earphones, and the headset will
automatically turn on and pair. This process takes about 5 seconds (the red and blue
light will flash quickly, but after the successful pairing, the red and blue lights will
flash slowly).
To pair it with your smartphone turn on Bluetooth on your device and find
A3-TWS, then click Pair  . After approximately five seconds, the headphones will be
paired, and the blue light flashes every five seconds.
If you want to use one headphone, take just one headphone out from the charging
case and start process of pairing with your smartphone.
Charging
When you charge your charging case, the red light will flash. When the
charging case is fully charged the red light will be turned on constantly.
The earphones will be automatically recharged when you put them in the
charging case. During this time, the blue light of the charging case and the red light
of the earphones will be turned on. After headphones are fully charged the indicator
lights will be off.
Turn on/off
The earphones will be automatically turned off when you place them in the
charging box. When you take them out they will turn on. When out of the charging
case, long press the earphone for four seconds to turn them off, then if you want to
turn them on, long press for three seconds.
Make a call
When the earphones are connected to the smartphone, you can make a call.
During the incoming call, touch the earphone, answer it, or keep your finger on a
headphone for a few seconds to reject it. During the call, tap the earphone to hang
up.
Music
While you are listening to music, tap the earphone to pause the song, then tap
it again to resume.
To turn the volume up tap the right earphone twice, to turn it down, tap the left
earphone twice.
To play the next song long press the right earphone until you hear the “beep” sound,
to play the previous do exactly the same thing, only with the right earphone.

2
Tips:
When only one earphone is connected to the smartphone, the other one is not
connected by default. For binaural use, please delete paired device, turn off the
Bluetooth on your phone, put the two earphones in the charging box then take them
out and wait for five seconds until they pair. Then, turn on the Bluetooth on your
smartphone, find A3-TWS, and click Pair.