TZ Medical TRIDENT NANO User manual

PATIENT
QUICK START GUIDE
TRIDENT™NANO HOLTER PATCH
For clinical support, please contact your medical provider.
For technical support related to your cardiac monitoring device, please call [phone] or email
clearbeatsuppor[email protected]. Include your name and preferred contact method (phone, email, other),
and a support representative will respond as soon as possible.
Step 1: Skin Prep
Step 4: Place Device
Step 7: Record Event Step 8: Remove Device Step 9: Charging
Step 5: Check Status Step 6: Status Lights
Step 2: Open Package Step 3: Insert Device
Remove all hair from electrode site
with a razor and scrub the electrode
application sites with alcohol wipe,
or warm soapy water. Dry area
thoroughly.
Open package and remove the
electrode.
Place the electrode on the chest at
a 45° angle. The “wings” should
span between the sternum and left
nipple with the device body towards
the left shoulder. Press firmly on all
parts of the electrode.
If you feel a symptom while wearing
the monitor, hold the button for 4
seconds to record the event. The
light will blink green and an “Event
Recorded” tone will play.
Check the recording status by briefly
pressing the button. The device will
blink 5 times with the color of light
indicating the status as shown to the
right.
Eject the device by firmly pressing
the front edge near the
status/event button and slide the
device upward. Then slowly peel
the electrode from your skin.
Slide the device into the electrode,
matching the picture on the
electrode. Hold the device in place
until the green light turns off. Peel
the release liner from the electrode.
Trident Patch
Monitoring Electrode
INSTRUCTIONS FOR USE
•Prep application area by shaving hair and thoroughly cleaning
and drying skin. Do NOT use alcohol. Leave no residue.
HPR-0058
LEFT
STERNUM
LEFT NIPPLE
3.
1. 2.
Trident Patch
Monitoring Electrode
INSTRUCTIONS FOR USE
•Prep application area by shaving hair and thoroughly cleaning
and drying skin. Do NOT use alcohol. Leave no residue.
HPR-0058
LEFT
STERNUM
LEFT NIPPLE
3.
1. 2.
PUSH
Push
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
Push
PUSH
Recording Electrode has poor
connectivity
Recording is
complete
Blinks green 5 times Blinks yellow 5 times
Blinks red 5 times
Device requires
charging
Blinks green & yellow
When the device requires charging
(alternating G-Y-G-Y-G light),
remove the device from the patch
electrode and insert into the
charging dock. A solid
green light will indicate
that the device is fully
charged.

TRIDENT™NANO
What you need to know
while monitoring...
TZ Medical Inc.
17750 SW Upper Boones Ferry Rd. #150
Portland, OR 97224
www.tzmedical.com
18905 R1.3
Allow electrode sites to dry completely and remove all residue before applying adhesive
electrodes.
Avoid fully submerging or exposing device to excessive amounts of water or moisture. The
device is water resistant, not waterproof. For optimal results, avoid spraying water directly
into the sensor. It is recommended to face away from the shower head while showering.
When inserting the recorder, firmly press and hold the exposed edge of the device closest
to the LED into the electrode patch until the green LED flashes and turns off. This is to
ensure that the device is properly recording and maintains a water-resistant seal while
showering.
It may be difficult to observe the LED while wearing the device. Viewing the LED can easily
be done by pressing the button while standing in front of a mirror.
If you need to apply a new electrode for an extended study, recharge the device and
repeat the instructions for application.
It is recommended to take a warm shower during the removal process of the electrode. If
available, apply mineral oil as you peel the electrode away to loosen the adhesive.