UBERHAUS DESIGN TGA65SG User manual

ASSEMBLY INSTRUCTIONS
DINING SET - TABLE
RONA CODE: 79275002
ITEM NUMBER: TGA65SG
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
PARTS LIST
PART
NO. PART CODE PART Q’TY
1
2
3
4
1
4
2
1
5
6
7
8
9
2
12
12
12
1
TGA65SG-CS01
TGA66SG-CS02
TGA65SG-CS02
62TGA65SGY101
17C01D0710001
17FD05040301
1800337001
17C17D1302001
17KAA0101----Y4
TABLE TOP
LEG
SUPPORT
CENTER CONNECTOR
WITH RING
SCREW ST4.2*10
BOLT M6*30
WASHER d6.5*D13*1.0
BOLT CAP M6
HEX.KEY WRENCH 4MM
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
up. Insert the legs (#2) and the supports (#3) into
the plastic holders attached on the underside of
the table top (#1) rim. See Figure 1.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard any of the packaging until you have checked that you have all the parts and pack of fittings.
Keep children away during assembly. This item contains small parts which can be swallowed by children.
Children should always be under direct adult supervision while using the product.
Retain the assembly instructions for future reference.
PAGE 1 OF 2 COURTYARD CREATIONS INC.
!
!
!
!
!
FIGURE 1
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #9)

Step 2:
Fasten the supports (#3) and the plastic holders on the
table top (#1) by using screws (#5). See Figure 2.
Step 3:
Fasten the center connector with ring (#4) to the middle
of the legs (#2) and supports (#3) by using bolts (#6)
and washers (#7). Make sure that all bolts are
tightened completely, and then cover them with bolt
caps (#8). See Figure 3.
Step 4:
Turn the table to its upright position. See Figure 4.
NOTE:
To use an umbrella with this table, please remove the
plastic center plug and put the umbrella pole through
the table top (#1) and center connector with ring (#4).
Cleaning and Maintenance
•Wash frame parts with mild soap and water, rinse
thoroughly, and dry frame completely. Do not use
bleach, acid, or other solvents on the frame parts.
•Wash glass with mild soap and water, rinse
thoroughly, and dry glass completely.
•Please inspect and tighten all bolts and fasteners on
a regular basis to ensure proper performance and
safety of your table.
•When moving the table, remove the umbrella. Do
not drag.
•We recommend the use of furniture covers when not
in use.
•In order to prolong the life and beauty of your table,
we recommend it be stored in a dry and protected
area during off season periods.
•Tempered glass has been used for increased strength and safety of your table. However, during
windy conditions the umbrella should be lowered and/or removed.
FIGURE 2
FIGURE 3
FIGURE 4
PAGE 2 OF 2
67
8
3