USAGE
Demontiramo zgornje nastavlji-
vo držalo (držalo ima dva vijaka
S17) • Dismount the upper adju-
stable holder (the holder has two
screws S17).
Skozi obroč vstavimo homoki-
netičen zglob z navojem naprej.
Vpnemo lahko zglobe z preme-
rom vratu od Ø18 do premera
Ø36 • Insert the homokinetic joint
through the ring with the threa-
ding head ahead. Tool can grasp
homokinetic joints with neck dia-
meters from Ø18mm trough dia-
meters of Ø36mm.
Pred vpetjem v primež (po pot-
rebi) nastavite ogrodje držala, z
pritiskom dveh gumbom (A in B)
na pravilno dolžino vratu zgloba
• Before applying tool into vice (if
needed) setup the right lenght by
pressing the two buttons (A and B)
to the suitable lenght.
Montiramo zgornje držalo , ter
hkrati privijemo 2 vijaka • Mount
the upper holder and at the same
time screw the two screws.
Na navoj zgloba privijemo ma-
tico homokinetičnega zgloba •
Screw on the nut of the homokine-
tic joint on the thread of the joint.
Snamemo vskočnik, ki drži man-
šeto zgloba • Dismount the circlip
which is holding.
Pričnemo privijati matico zgloba
saj s tem razstavimo homokine-
tičen zglob • Start to screw in the
nut of the joint with which you dis-
mount the homokinetic joint.
The manufacturer accepts no
responsibility for misuse or any
use that is not in compliance
with the contents of this manual
instruction.
•
Proizvajalec ne prevzema
nobene odgovornosti za splošno
nepravilno uporabo orodja in
nepravilno uporabo orodja ki ni v
skladu z navodili izdelka.
