Unior 1693.2 User manual

Wall and bench
swiveling vice jaw
Glava vpenjalna s
fiksiranjem na pult
ali zid
WARNING
1. Some bike manufacturers recommend not clamping
thin-walled carbon fiber frames. Consult manufacturer
for suggested clamping location.
2. To avoid damage to the seatpost or bike frame,
always clean the clamping position on the bike and the
jaws before clamping.
OPOZORILO
1. Nekateri proizvajalci koles priporočajo da tanjših
karbonskih koles ne vpenjate. Posvetujte se z vašim
proizvajalcem koles za pravilno uporabo.
2. Da se izognete poškodbam okvirja ali sedežne
opore kolesa, vedno očistite mesto vpenjanja in čeljust
stojala.
Unior d.d.
Kovaška cesta 10
3214 Zreče, Slovenia
T: [phone]
F: [phone]
[e-mail]
www.uniorbiketools.com
1693.2
EN
SLO
uniorbiketools.com

To adjust bike stand head position,
release lever (E) and adjust/rotate the
head (F). • Za nastavitev glave stojala
sprostite vzvod (E) in nato nastavite
željeno pozicijo (F) glave stojala.
Adjust opened jaws (G) to seatpost
or bike tube. Turn handle (H) until
jaws firmly grabs the tube. • Nastavite
odprto čeljust (G) sedežno oporo ali cev
okvirja. Obrnite ročaj (H) dokler čeljusti
ne zajamejo celotne cevi.
A
C
B
D
E
F
G
H
I
J
A
C
B
D
E
F
G
H
I
J
INSTALLATION SAMPLES
ADJUST VICE JAWS CLAMPING BIKE
RELEASING BIKE
When mounting swiveling vice jaw
on the workbench (A), always mount
like shown above. Mount jaw with
two screws (B) that are included. •
Vpenjalno glavno privijemo na delovni
pult (A) s pomočjo dveh priloženih lesnih
vijakov (B) kot prikazuje slika.
Firmly hold bike frame (I). Flip handle
(J) to quickly release tube from jaws.
• Trdno primite okvir kolesa (I). Obrnite
ročaj (J) za hitro sprostitev cevi iz čeljusti
orodja.
When mounting swiveling vice jaw to
the wall, always mount plate and jaw
like shown above. Screw vice jaw with
four screws to the wall. • Vpenjalno
glavo privijemo na zid (C) s pomočjo
štirih priloženih vijakov (D) kot prikazuje
slika.
A
C
B
D
E
F
G
H
I
J
A
C
B
D
E
F
G
H
I
J
A
C
B
D
E
F
G
H
I
J