NOTE:
Make sure the batteries provided in the packing, is fully charged before first use.
Charge the battery for about 3 hours before first use.
RF Transmission of the Transmitter will automatically switch OFF in approximately
5 minutes if there is no Audio Signal, or the Signal that it receives from the Audio
Source is too weak for proper reception. However, if the Signal returns to an
acceptable level, the Transmitter will automatically switch ON again.
CHARGING THE BATTERIES
1. Select the On/Off Switch in the
Headset Receiver to OFF position.
2. Place the Headphone Receiver on
the Transmitter, make sure the Charge
Contact touches the Charge Pins on the
Transmitter.
3. The Charging process starts automatically.
LED Indicator of Main Battery then glows in
Red constantly. It will glows in Green about 2 hours
after the battery is fully charged.
4. A spare battery is provided for sustained enjoyment.
Simply insert it into the Transmitter for Charging.
LED Indicator of Spare Battery will then glow in
Red constantly. It will glows in Green about 2 hours
after it is fully charged.
WARNING:
Never attempt to recharge conventional dry cells.
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such
