Unitech EA630 User manual

Package
Please make sure the following contents are in the gift box.
V 1.1
If something is missing or damaged, please contact your unitech representative.
The basic package contents
EA630 Single Slot Cradle ( with Detachable Part )
5V/3A adapter with US/EU/UK plugs
EA630 Single Slot Cradle
Quick Start Guide
How to use EA630 single slot cradle
There are two ways to charge the EA630 terminal :
￭You can directly charge EA630 without the boot case on and slide it into the cradle.
￭To charge EA630 with the boot case on, please remove this detachable part from the cradle before charging.
Here is the detachable part :
LED Indicator Status
When the cradle is under standby mode:
Blue LED Power is on
When battery is charging:
Red LED
Blue LED
Battery is being charged in rear slot
Battery charging is completed
When EA630 is inserted in the cradle, the LED indicator on the cradle
will not be changed. The charging status is indicated by the LED of
EA630:
Red LED
Green LED
EA630 is being charged
EA630 charging is completed
￭EA630 Single Slot Cradle
EA630 1-Slot Charging
Cradle w/ spare battery slot
EA630 1-Slot USB Cradle
w/ spare battery slot
EA630 1-Slot Ethernet
Cradle w/ spare battery slot
* The type-C hole is for the
display port, not for USB client.

How to remove the detachable part
There are two hooks on each side of the cradle.
Insert your thumb tip from this direction as shown in the photo, grab the edge and slightly pull the detachable part apart from
both sides to get it unhooked from the cradle.
EA630 single slot cradle part numbers information
P/N Models Description
5000-900072G
EA630 1-Slot Charging
Cradle w/ spare battery slot
Charging terminal via DC jack
5000-900070G
EA630 1-Slot USB Cradle
w/ spare battery slot
Charging terminal via DC jack
Data transfer by USB type C between terminal and PC
5000-900071G
EA630 1-Slot Ethernet
Cradle w/ spare battery slot
Charging terminal via DC jack
Data transfer by Ethernet (RJ45) or USB host (2.0)
Display Port via USB type C (DP only)
CAUTION!  To ensure the unit working properly, please keep all connectors
away from the contaminants staying inside of them such as dust,
grease, mud, and water. The negligence may cause the unit with
no communication, short circuited, overheated and so on.
 If the connector is damaged, please ensure the connector is being
fully repaired before using the unit to avoid causing short circuited.
http://www.ute.com/
Copyright 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.