Unitron iCube II Manual

iCube II
Setup instructions
iCube II is compatible with all Era™and North
platform wireless hearing instruments and can be
used for regular ttings, as well as Flex:trial.
™

Here are the steps to congure the iCube II in
Unitron TrueFit™soware:
Step 1
Enable iCube II for tting
Go to Options > Preferences > Fitting Device > iCube and check the box Enable iCubeII
for tting.

Step 2
Pairing
The iCube II can be paired in the soware in three dierent ways:
a. Using a wired connection:
Go to iCube II connected via USB and follow the steps (same steps as with previous iCube).
b. Using the Bluetooth adapter that comes with the new iCube II:
The adapter has to be connected to the USB port of the computer.
Verify that iCube II is turned on, press and hold the pairing button (< >) on the side until
the three LED lights flash.
Then, click on the Pairing Assistant button and follow the instructions on the screen.
c. Using iCube II via Bluetooth:
Press and hold the pairing button (< >) on the side until the three LED lights flash to set
the iCube II on pairing and follow the 4 steps on the screen.

Step 3
Check the connection
Click on the Check Connection button. A green check mark will appear next to the iCube II.
Step 4
End setup
The nal step is to go to Instruments > Selection and select the iCubeII as your
programming interface.
Previous wireless products, like Passport™and Latitude,
™will require the original iCubeI
for wireless programming, or a wired connection via HiPro or NoahLink.
14-050 027-5915-02
unitron.com