Universal Furniture EXPLORE HOME 572210 User manual

INSTRUCTION SHEET
572210/57221F/572220/57222F/572221F UPHOLSTERED BED
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
Assembly Procedure: (Please follow the sketches below.)
Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware. Make sure the quantity of each
is correct.
Step 1: Screw the Upper part of leg(C) to the Headboard (F) and then through the Center part of leg (A) screw the
Bottom part of leg (D) to Upper part of leg(C).
Step 2: Install the Bedrail leg (I) to the Side rail (G) with Flat washer (8), spring washer (2) and Phillip head bolt (7) using
Wrench (6).
Step 3: Screw the Upper part of leg(C) to the Footboard (H) and then through the Footboard stretch (E) screw the Bottom
part of leg (D) to Upper part of leg (C).
Step 4: Assemble the Side rail (G) to the Headboard (F) and Footboard (H) with Bolt (1), Curved washer (3), spring
washer (2) and Nut (4). Tighten them by Wrench (6).
Step 5: Screw the Slat center support (B) to the Slat Panel (J) by hand.
Step 6: Screw (5) the Slat panel (J) to the side rail (G) using screwdriver (not provided).
Note: 572210/57221F has 3pcs Center Supports
Assembly is now complete.
PARTS LIST
Headboard
Side Rail
Footboard
Slat Panel
Slat center
support
Center part
of leg
Upper part
of leg
Bottom
part of leg
Footboard
Stretch
Bedrail leg
SCREW
WRENCH
HARDWARE PACK (F)
BOLT
SPRING
WASHER
CURVED
WASHER
NUT
FLAT
WASHER
PHILLIP HEAD
BOLT

GOOD, AFFORDABLE, SMART DESIGN.
INSTRUCTION SHEET
572210/57221F/572220/57222F/572221F UPHOLSTERED BED
Step 1
A
A
F
D
D
C
C
Step 2
I
G
8
2
7
6
Step 3
C
D
E
H
Step 5
B
J
Step 4
Step 6
B
J
B
G