Universal Remote Control PCL-300 User manual

PCL-300 PC Upgrade Link
Archive Configurations on the
Omega (MX-650) and the Osiris (MX-350)
The PCL-300 is designed to enable the professional installer to archive
configurations programmed on either the MX-650 or the MX-350
remote controls so that the configurations can be reused in the future
without repeating the programming process. Downloading a previously
programmed configuration often provides a better starting point for
programming and speeds customization even if the new system is
slightly different from an archived file. The PCL-300 software
includes a completely blank configuration for each of the remotes.
These blank configurations have all labeling and codes deleted
from all devices and buttons, enabling you to program small
systems without extensive deleting of labels or commands.
The PCL-300 also enables you to update the IR Database in the remote control and to
update the operating system of the remote control itself whenever an improvement is
available. By connecting to the internet, then using the Live Update feature, you can
update the control itself.
The PCL-300 does not enable you to make any changes to an MX-650 or MX-350
configuration via the PC. All programming is done on the remote control. Nor does
the PCL-300 allow you to convert an MX-650 configuration to an MX-350
configuration or vice versa.
COMPLETE ™
CONTROL
COMPLETE

Live Updates Quickly and Easily
The PCL-300 software can be updated with new IR code sets for the remote
control’s database and new firmware. To obtain the latest IR database and
firmware, simply connect to the internet in your normal way, then open PCL-300
software. Once the update is complete, close PCL-300 software. The changes only
take effect when you restart the program. You do not have to reboot your PC.
500 Mamaroneck Avenue, Harrison, NY 10528 Phone: [phone] Fax: [phone]
www.universalremote.com
COMPLETE ™
CONTROL
COMPLETE
Specifications
Software: Windows PC Only
USB: 1.1
Weight: 10.4 oz.
Size: 7.17" x 4.76" x 1.18"
Connecting to either the MX-350 or the MX-650
1. Open the battery compartment of the remote and remove at least
two batteries to reveal the multi pin connector for the PCL-300.
2. Note that one pin on the connector attached to
the PCL-300 is filled in. Orient the connector of
the PCL-300 so that the filled in pin will match the
pin pattern of the socket inside the remote control.
3. Carefully fit the plug from
the PCL-300 into the socket
on the remote control.