Urban Electric NEEDLES CLEAN LARGE Quick start guide

NEEDLES CLEAN LARGE
ASSEMBLY AND MOUNTING INSTRUCTIONS MB-2238HL
GENERAL NOTES
•THIS LUMINAIRE IS SUITED FOR DAMP LOCATIONS.
•THIS LUMINAIRE IS UL LISTED. WHEN INSTALLING LUMINAIRE,
CONFORM TO ALL APPLICABLE LOCAL ELECTRICAL CODES,
ORDINANCES, AND THE NATIONAL ELECTRICAL CODE (NEC).
•FOR YOUR SAFETY AND PROPER OPERATION OF LUMINAIRE,
READ AND UNDERSTAND ALL INSTRUCTIONS COMPLETELY
BEFORE COMMENCING INSTALLATION OF THIS LUMINAIRE.
•CAREFULLY UNPACK THE LUMINAIRE AND INSPECT FOR DAMAGE.
•THIS PRODUCT IS RATED FOR:
•ONE 60W MAX, TYPE A BULB.
•SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CAUTION
THIS PRODUCT SHOULD BE INSTALLED ONLY BY A LICENSED
ELECTRICIAN. PLEASE WEAR GLOVES TO PROTECT THE FINISH OF
THE FIXTURE.
THIS FIXTURE WEIGHS APPROXIMATELY 40 LBS.
WARNING
THE ELECTRICITY MUST BE TURNED OFF AT THE MAIN FUSE BOX
BEFORE INSTALLING THIS LUMINAIRE. TURNING POWER OFF USING
THE LIGHT SWITCH MAY NOT BE SUFFICIENT TO PREVENT
ELECTRICAL SHOCK.
COMPONENTS PROVIDED FOR INSTALLATION
FIXTURE BODY
CANOPY
ELECTRICAL
ASSEMBLY
MOUNTING ASSEMBLY
CHAIN (X3) 15 LINKS
EACH
OVERALL HEIGHT
CHAIN
BULB
WIRE NUTS
HEX WRENCH

NEEDLES CLEAN LARGE
ASSEMBLY AND MOUNTING INSTRUCTIONS MB-2238HL
MOUNTING INSTRUCTIONS - TWO PERSON INSTALL
STEP 1
ATTACH OVERALL HEIGHT CHAIN TO ELECTRICAL ASSEMBLY.
SLIDE CANOPY DOWN CHAIN.
RUN WIRES UP THROUGH CHAIN AND MOUNTING ASSEMBLY
LOOP.
ATTACH CHAIN TO MOUNTING ASSEMBLY.
STEP 3
SHUT OFF THE MAIN ELECTRICAL SUPPLY TO THE JUNCTION BOX FROM
THE FUSE BOX/CIRCUIT BREAKER. TURNING POWER OFF AT THE SWITCH
IS NOT SUFFICIENT.
RAISE MOUNTING ASSEMBLY TO CEILING AND ATTACH TO JUNCTION
BOX USING JUNCTION BOX SCREWS.
MAKE ELECTRICAL CONNECTIONS WITH PROVIDED WIRE NUTS AND
WRAP IN UL RATED ELECTRICAL
TAPE.
STEP 3
SLIDE CANOPY TO CEILING AND SECURE WITH SET SCREWS.
STEP 5
ATTACH THE THREE SETS OF FIFTEEN LINK CHAIN TO ELECTRICAL
ASSEMBLY.

NEEDLES CLEAN LARGE
ASSEMBLY AND MOUNTING INSTRUCTIONS MB-2238HL
STEP 5
ONCE CHAIN IS ATTACHED TO ELECTRICAL ASSEMBLY,
INSTALL BULB.
STEP 6
RAISE FIXTURE BODY TO THE CHAIN AND ATTACH TO LOOPS ON FIXTURE
BODY.
STEP 7
RESTORE POWER TO THE CIRCUIT. CONFIRM PROPER
OPERATION OF THE LIGHT FIXTURE.
ELECTRICAL CONFIGURATION TABLE
FROM HOME
FROM LUMINAIRE
GENERAL NOTE: USE UL LISTED WIRE NUTS FOR
THE WIRING CONNECTIONS IN THIS LUMINAIRE.
WRAP WIRE NUT CONNECTIONS WITH UL LISTED
ELECTRICAL TAPE.
FOR QUESTIONS, PLEASE CONTACT CLIENT
SERVICES AT: 843.723.8140 OR
[e-mail]
CONNECT BLACK OR RED (HOT)
HOUSE SUPPLY CIRCUIT WIRE
TO:
LUMINAIRE ROUND/BLACK
WIRE (HOT)
CONNECT WHITE (NEUTRAL)
HOUSE SUPPLY CIRCUIT WIRE
TO:
LUMINAIRE RIBBED/WHITE
WIRE (NEUTRAL)
CONNECT GREEN INSULATED OR BARE COPPER (GROUND -)
HOUSE SUPPLY CIRCUIT WIRE AND LUMINAIRE BARE STRANDED
WIRE (GROUND -) TO GREEN GROUND SCREW ON CROSSBAR.