URC Total Control MRX-5 User manual

MRX-5
Owner’s Manual
Total Control MRX-5
Owner’s Manual

Total Control MRX-5
Owner’s Manual
Rev 1.0
Technical Suppor t
Toll Free: 800-904-0800
Main: 914-835-4484
[e-mail]
H o u r s : 9 : 0 0 a m - 5 : 0 0 p m E S T M - F
Table of Contents
Introduction ........................................................................................................................................................................................................................................................................1
Front Panel Description ...................................................................................................................................................................................................................................................2
Rear Panel Description ....................................................................................................................................................................................................................................................3
Bottom Panel Description................................................................................................................................................................................................................................................4
Installin the MRX-5 .........................................................................................................................................................................................................................................................5
Network Installation..................................................................................................................................................................................................................................................5
Connectin IR Emitters..............................................................................................................................................................................................................................................6
Connectin RS-232 (Serial).......................................................................................................................................................................................................................................7
Specifications ....................................................................................................................................................................................................................................................................8
Limited Warranty Statement............................................................................................................................................................................................................................................8

1
Total Control MRX-5
Owner’s Manual
Introduction
The MRX-5 Advanced Network System Controller controls is designed to meet the
needs of residential or small commercial environments.
Only Total Control software products and user interfaces are supported by this
powerful device.
This device is not compatible with Total Control 1.0 legacy products.
Features and Benefits
• Stores and issues commands for all IP IR and RS-232 controlled devices.
• Provides two-way communication with Total Control user interfaces.
(remotes and keypads).
• Easy rack-mounting via the included rack mountin ears.
Parts List
The MRX-5 Advanced Network Controller includes:
• 1x MRX-5 System Controller
• 1x AC Power Adapter
• 4x IR Emitters 3.5mm (standard)
• Wall Mount and 4x Screws

2
Total Control MRX-5
Owner’s Manual
Front Panel Description
The front panel of the MRX-5 Advanced Network System Controller displays the
following information:
1. Power LED: Indicates three (3) possible states:
■Solid Blue: The device is receiving power and has successfully
booted up.
■Blinkin Blue: The device is receiving power but is still initializing.
■Off: The device is not receiving power.
2. Network LED: Indicates three (3) possible states:
■Solid Blue: The device is connected to the network and has
received an IP address.
■Blinkin Blue: The device is connected to the network but has
not yet received an IP address.
This LED blinks blue after a Total Control conguration le has
been downloaded to the device.
■Off: The device is not connected to the local network.
1 2

3
Total Control MRX-5
Owner’s Manual
Rear Panel Description
The rear panel of the MRX-5 Advanced Network System Controller displays the
following information:
1. DC 12V: Connect the supplied power adapter to this port the Power LED
becomes solid blue when the device has received power.
2. IR Outputs: Four (4) standard 3.5mm IR emitter ports. IR Output 4 provides
variable level adjustment.
3. RS-232 Port: One (1) RS-232 ports support Tx(Transmit) Rx(Receive) and
GND(Ground) connections for two way communication.
Compatible with URC cables RS232F and RS232M.
4. USB Port: Designed for future use.
5. LAN Port: RJ45 standard 10/100 Ethernet connection to the
local network.
1
23
4
5

4
Total Control MRX-5
Owner’s Manual
Bottom Panel Description
The bottom panel of the MRX-5 Advanced Network System Controller displays the
following information:
1. Reset Button: Located at the bottom of the device and requires a stylus or
paper clip to press. Performs two (2) possible actions:
■Sin le Tap: Power cycle the device.
■Press-N-Hold: Press this button for 15 seconds to restore the
device to its factory settings. This action cannot be reversed and the
device REQUIRES re-programming with the Total Control software.
2. Mountin Plate: Slide the mounting plate up or down to remove it from
the device. Use the four (4) supplied mounting screws to mount the MRX-5
on a wall ceiling or any other convenient location.
1
2

5
Total Control MRX-5
Owner’s Manual
1
2
Installin the MRX-5
The MRX-5 Advanced Network System Controller can be installed almost anywhere in
the home.
Once physically installed it requires pro rammin by a certified URC inte rator in
order to operate local equipment using IP (Network) RS-232 (Serial) IR (Infrared) or
relays. All cables must be connected to their respective ports at the rear of the device.
Network Installation
1. Connect an Ethernet cable (RJ45) to the rear of the MRX-5 and the onto
an available LAN port of the network’s local router (Luxul preferred).
2. A certied URC integrator is required for this step congure the MRX-5 to
a DHCP/MAC reservation within the local router.

6
Total Control MRX-5
Owner’s Manual
Connectin IR Emitters
IR emitters are used to communicate to AV devices such as cable boxes televisions
blu-ray players and more.
1. Plug IR Emitters (four (4) supplied in the box) into any of the four (4) IR
outputs available on the rear of the MRX-5.
IR Output 4includes an adjustable sensitivity dial. Turn this dial to the right
to increase the gain and to the left to decrease it.
2. Remove the adhesive coverin from the emitter and place it over the IR
receiver of the 3rd party device (cable box television etc.).
1
2

7
Total Control MRX-5
Owner’s Manual
Connectin RS-232 (Serial)
The MRX-5 can operate equipment via RS-232 communication. The allows discrete
serial commands to be triggered from the Total Control system.
Connect an RS-232 device using URC’s proprietary RS-232 cables. These use either
male or female DB-9 connections with standard pin-outs.
1. Connect the 3.5mm into the RS-232 Output available on the MRX-5.
2. Connect the Serial connection onto the available port on the 3rd party
device such as AVRs Televisions Matrix Switchers and other devices.
1
2

8
Total Control MRX-5
Owner’s Manual
Specifications
Network: One (1) 10/100 RJ45 Ethernet port (two LED indicators)
Processor: ARM9 Thumb Processor 400 MHz
RAM: DDR2 256 MB
Stora e: e.MMC NAND 4GB
Wei ht: 6 oz
Power: DC 12V/1.0A
IR Outputs: Four (4) IR outputs (IR attenuator on output 4)
RS-232: One (1) RS-232 port
USB Port: For Future Use
Limited Warranty Statement
https://www.urc-automation.com/legal/warranty-statement/
End User A reement
The terms and conditions of the End User Agreement available at
https://www.urc-automation.com/legal/end-user-agreement/ shall apply.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and if not
installed and used in accordance with the instructions may cause harmful interference
to radio communications. However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception which can be determined by turning the equipment off
and on the user is encouraged to try to correct the interference by one more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

9
Total Control MRX-5
Owner’s Manual
Re ulatory Information to the User
• CE conformity Notice Products with “CE” marking comply EMC Directive
2014/30/EU issued by the commission of the European Community.
1. EMC Directive
• Emission
• Immunity
• Power
• Declaration of Conformity
“Hereby Universal Remote Control Inc. declares that this MRX-5 is in compliance
with the Essential requirements.”
Warnin !
The manufacturer is not responsible for any Radio or TV interference caused by
unauthorized modications to this equipment.
Changes or modications not expressly approved by the manufacturer could void the
user's authority to operate the equipment.