USX-MOUNT XAS405-1 User manual

XAS405-1
INSTRUCTION MANUAL
For 13-27" TV
If you have any questions along the way, just give us a call
1-800-460-0956 or mail to [email protected].
We’re ready to help!
R

Before getting started, let’s check below lists to make sure it is just right for you!
2
3
4
2
Does your monitor
(including accessories)
weigh MORE than
17.6 lbs. (8 kg)?
Do you have
all the tools
needed?
(NOT INCLUDE) Tape
Measure
CAUTION
Screw
driver
No? Perfect – you may continue.
Yes? This mount is NOT compatible.
CAUTION: DO NOT exceed the maximum weight
indicated. This mounting system is intended for use only
with the maximum weights indicated. Use with products
heavier than the maximum weights indicated may result
in collapse of the mount and its accessories, causing
possible injury.
● Do not use this product for any purpose not explicitly specified by manufacturer
● Manufacturer is not responsible for damage or injury caused by incorrect assembly or use
1
Check your monitor
VESA is within
Min and Max size
No? This mount is NOT compatible.
Yes? Perfect !
MAX:100mm/3.94"
(MIN:50mm/1.97")
MAX:100mm/3.94"
(MIN:50mm/1.97")
Please read this instruction carefully before installation.
If you do not understand these instructions or have doubts about the safety of the
installation, assembly or use of this product, please feel free to contact Customer
Service:
E-mail: [e-mail]
Phone call: 1-800-460-0956

3
3D
SIDE VIEW
+45°
-45°
FRONT VIEW
SIDE VIEW
FRONT VIEW
SIDE VIEW
93mm
[3.66in]
±360°
±90°
100mm
[3.94in]
100mm
[3.94in]
405mm
[15.95in]

Never use damaged parts!
NOTE: Not all hardware included will be used.
4
M4x12mm
M5x12mm
M6x12mm
M4/M5
M6
Washers
TV Screws
x4
x4
x4
x8
x8
-Monitor Connection x1
WARNING:This product contains small items that could be a choking hazard if swallowed. Before starting assembly,
verify all parts are included and undamaged.
Parts and Hardware for Monitor Installation

Parts and Hardware for Monitor Arms Assembly
5
-Base x1
-M5x15 Bolts x3
-3mm Wrench x1
-Support Tube x2
-5mm Wrench x1
-Pole folder x1
-Pole x1
-M6x10 Bolts x4

6
Pole Unit

1:Put the pole on the base and use wrench to fasten bolts fully.
2:Install the two support tubes into base by using wrench to fasten the bolts .
7

3-1 Assemble Monitor Connection with Monitor
Choose the suitable bolts and washers according to the diameter of the hole
at the back of the monitor .
No!
Monitor Connection
UP
8

3-2 Connect the Monitor Connection and Fixed Assembly
Monitor
1 2
Use the wrench to fasten or loosen the bolt ① to adjust the height of monitor connection.
Tighten
1
9
Fully fasten bolt ① when finish.

Tilting (±45°) and leveling
±45°
±90°
10