V-tech Marble Rush Assembly Instructions

Parent's Guide
91-003989-001 UK
Marble Rush™ Launch Pad

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
INTRODUCTION
Thank you for purchasing the Marble Rush™ Launch Pad!
Get ready for a rush of non-stop action! Build thrilling courses, send the
marbles into motion and compete with family and friends through exciting
challenges complete with sounds and lights. Please refer to the colour
manual for detailed assembly steps.
INCLUDED IN THIS PACKAGE
• Marble Rush™ Launch Pad
• Parent’s guide
• Colour manual
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of this
toy and should be discarded for your child’s safety.
NOTE: Please keep this Parent's Guide as it contains important information.
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the unit. Use a screwdriver to loosen the
screw. Then, remove the cover.
3. If used batteries are present, remove these
batteries from the unit by pulling up on one
end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery
box. (For best performance, alkaline
batteries or fully charged Ni-MH
rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.

3
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be
used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
Australia/New Zealand:
If you think batteries might have been swallowed or placed inside any part
of the body, immediately call the 24-hour Poisons Information Centre on 13
11 26 (in Australia) or 24-hour National Poisons Centre on 0800 764 766 (in
New Zealand) for fast, expert advice and go straight to the nearest hospital
emergency room.

4
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and batteries,
or on their respective packaging, indicates they must not be
disposed of in domestic waste as they contain substances that
can be damaging to the environment and human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate that
the battery contains more than the specified value of mercury
(Hg), cadmium (Cd) or lead (Pb) set out in the Batteries and
Accumulators Regulation.
The solid bar indicates that the product was placed on the market
after 13th August, 2005.
Help protect the environment by disposing of your product or
batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

5
12
6
7
8
11
12
13
14
15
16
17
10
9
3
4
5
LABEL APPLICATION
Please securely stick the labels to the play set as indicated below:

6
1
6
2
78 8
4 5
10
13
3
11
14 15 16
9
1712
B-02
M-02
T-04
B-04
T-03
M-01
M-05
M-06
T-01
M-07
M-11
T-02
M-04
M-14

7
PRODUCT FEATURES
1. Rocket Sensor
When the Rocket Sensor detects a ball, the unit
will play sound effects.
2. Rocket Button
Press the button on the rocket to select the
background music.
3. Music/SFX Switch
Slide the switch all the way to the right to turn on both music and SFX. The
middle position plays SFX only with no background music. Slide the switch
all the way to the left to turn off both SFX and background music.
4. On/Off Switch
Slide the switch to the Off position or the On
position to turn the unit Off or On.
5. Automatic Shut-Off
To preserve battery life, the Marble Rush™ Launch Pad will
automatically power-down after several minutes without input. The unit
can be turned on again by sliding the On/Off Switch to the on position or
by sliding the Music/SFX Switch to a different position. The unit will also
automatically turn off when battery power is very low.

8
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth. Never use
solvents or abrasives.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended period
of time.
4. Do not drop the unit on a hard surface and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working, please follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit back On. The unit should now be ready to play with again.
5. If the unit still does not work, install a new set of batteries.
If the problem persists, please contact our Consumer Services Department,
and a service representative will be happy to help you.

9
CONSUMER SERVICES
Creating and developing VTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make every effort
to ensure the accuracy of the information, which forms the value of our
products. However, errors sometimes can occur. It is important for you to
know that we stand behind our products and encourage you to call our
Consumer Services Department with any problems and/or suggestions that
you might have. A service representative will be happy to help you.
UK Customers:
Phone: [phone] (from UK) or [phone] (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: [phone]
Website: support.vtech.com.au
NZ Customers:
Phone: [phone]
Website: support.vtech.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER
GUARANTEES
Under the Australian Consumer Law, a number of consumer guarantees apply
to goods and services supplied by VTech Electronics (Australia) Pty Limited.
Please refer to vtech.com.au/consumerguarantees for further information.