V-tech Switch & Go Dinos Bash the Triceratops Assembly Instructions

Bash the TriceratopsBash the Triceratops
用户手册
Parent’s Guide

3
INTRODUCTION
Switch into fun with the Switch & Go Dinos®Bash the Triceratops. In a
few simple steps you can switch this powerful Triceratops into a speedy
roadster and back again! Ready to smash and crash? Here we go!
Crash Trigger
Off/Low/High Volume Switch
Sound Button

4
INCLUDED IN THE PACKAGE
• Switch & Go Dinos®Bash the Triceratops
• Parent’s Guide
WARNING: All packing materials such as tape, plastic sheets,
packaging locks, removable tags, cable ties, cords
and packaging screws are not part of this toy and
should be discarded for your child’s safety.
NOTE: Please keep this parent’s guide as it contains important
information.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a coin or a
screwdriver to loosen the screw.
Then, remove the cover.
3. If used or spent batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AA (LR6/AM-3) batteries
following the diagram inside the
battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicatethatthebatterycontainsmorethanthespecied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

7
PRODUCT FEATURES
1. Off/Low/High Volume Switch
To turn the unit On or to adjust the
volume, slide the switch to Low or
High . To turn the unit Off, slide the
switch to Off .
2. Sound Button
Press the Sound Button to hear fun
phrases and cool dinosaur sounds in
Dino mode, or to hear fun phrases and
exciting car sounds in Vehicle mode.
3. Crash Trigger
Hit the Crash Trigger to hear dino
sounds and to see the top half of the
head, neck and dino body pop up in Dino
modewiththerelighteffect.InVehicle
mode, hit the Crash Trigger to hear vehicle sounds and to see the
bonnet, half of the windscreen and one side of the door flash with a
light effect.
4. Automatic Shut-Off
To preserve battery life, the unit will automatically turn off after
approximately 40 seconds without input. The unit can be turned on
again by pressing the Sound Button, hitting the Crash Trigger, or
by switching between Dino mode and Vehicle mode. The unit will
also automatically turn off when battery power is very low.

8
HOW TO SWITCH
2. Flip the crest down and
toward the dino’s head.
1. Dino mode.
3. Pull the front legs up and
toward the dino’s head.
5. Flip the tail down.
4. Swing the legs out.
6. Snap the legs up and
toward the dino’s body.
The unit is now in Vehicle
mode.
NOTE
To switch the vehicle back into a
dinosaur, follow the above steps in
reverse order.

9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit back On. The unit should now be ready to use
again.
5. If the unit still does not work, insert a new set of batteries.
If the problem persists, please contact our Consumer Services
Department and a service representative will be happy to help you.

10
CONSUMER SERVICES
Creating and developing VTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make
every effort to ensure the accuracy of the information, which forms
the value of our products. However, errors sometimes can occur.
It is important for you to know that we stand behind our products
and encourage you to call our Consumer Services Department with
any problems and/or suggestions that you might have. A service
representative will be happy to help you.
UK Customers:
Phone: [phone] (from UK) or [phone] (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: [phone]
Website: support.vtech.com.au
NZ Customers:
Phone: [phone]
Website: support.vtech.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED –
CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer
guarantees apply to goods and services supplied by VTech
Electronics (Australia) Pty Limited. Please refer to vtech.com.au/
consumerguarantees for further information.