V-tech Switch & Go Triceratops Bulldozer Assembly Instructions

用户手册
US CA
91-003355-005
Parent’s Guide
TRICERATOPS BULLDOZER

3
INTRODUCTION
Thank you for purchasing the Switch & GoTM Triceratops Bulldozer.
Engage your imagination with the hard-working bulldozer that
transforms into a fearsome triceratops. Sound effects and phrases
bring the action to life in your very own dinosaur universe.
Off/Low/High Volume Selector
Talk Button
Action Button
Sound Effect
Button
LCD Screen

4
INCLUDED IN THIS PACKAGE
• Switch & GoTM Triceratops Bulldozer
• Parent’s guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE
Please keep this parent’s guide as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide des parents car il comporte des
informations importantes
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (LR03/AM-4)
batteries following the diagram inside
the battery box.
5. Replace the battery cover and tighten
the screw to secure.

5
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity (+ and - ).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Donotdisposeofbatteriesinre.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under
adult supervision.
MISE EN GARDE
• Utiliser des piles alcalines neuves pour des performances
maximales.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mélanger différents types de piles ou d’accumulateurs,
ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés.
• Ne pas utiliser des piles ou des accumulateurs endommagés.
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et - .
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le -) .
• Enlever les piles ou les accumulateurs usagés du jouet.
• Retirer les piles ou les accumulateurs en cas de nonutilisation
prolongée.
• Ne les jeter ni au feu ni dans la nature.
• Ne pas tenter de recharger des piles non rechargeables.
• Enlever les accumulateurs du jouet pour les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.

6
PRODUCT FEATURES
1. Off/Low/High Volume Selector
To turn the unit On or adjust the volume,
slide the Off/Low/High Volume Selector
to Low or High .To turn the unit
Off, slide the selector to Off .
2. Talk Button
Press the Talk Button to hear fun dino
and driver phrases.
3. Sound Effect Button
Press the Sound Effect Button to
hear cool dinosaur and bulldozer sound
effects.
4. Action Button (Dino Mode Only)
Press the Action Button to see the
dino’s head move and mouth light up.
5. Motion Sensor
Move the triceratops to activate the Motion Sensor and hear
walking sound effects in Dino mode. In Vehicle mode, move the
bulldozer to hear driving sound effects.
6. Automatic Shut-Off
To preserve battery life, the Triceratops Bulldozer will automatically
shut off after several seconds without input. The unit can be turned
on again by pressing the Talk Button or Sound Effect Button.

7
NOTE
If the unit powers down or if the light fades out during play, please
install a new set of batteries.
TRANSFORMATION
1. Begin in Dino mode. 2. Move the head shield
forward.
3. Rotate the front legs to
reveal the tires.
4. Rotate the rear legs to
create the front tires of
the vehicle.
5. Fold the tail onto the top. 6. Finish in Vehicle mode.

8
NOTE
To switch the vehicle back into a dino, follow the above steps in
reverse order.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit back On. The unit should now be ready to
use again.
5. If the unit still does not work, insert a new set of batteries.

9
IMPORTANT NOTE
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S.,1-877-352-8697 in
Canada, or visit our website vtechkids.comandlloutourContact
Us form located under the Customer Support link. Creating and
developing VTech products is accompanied by a responsibility that
we take very seriously. We make every effort to ensure the accuracy
of the information, which forms the value of our products. However,
errors sometimes can occur. It is important for you to know that
we stand behind our products and encourage you to contact us
with any problems and/or suggestions you might have. A service
representative will be happy to help you.

10
CAUTION
Changesormodicationsnotexpresslyapprovedbytheparty
responsible for compliance could void the user’s authority to operate
the equipment.
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

11
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 1951
Product Name: Switch & Go™ Triceratops Bulldozer
Responsible Party: VTech Electronics North America, LLC
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com