V-tech Toot-Toot Cory Carson DJ Train Trax & the Roll... Assembly Instructions

DJ Train Trax & the Roll Train
Parent’s Guide
91-003795-000 UK

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
Dancing Platforms
SmartPointTM Location
Mini Cory Mini Chrissy
Spinning Handle
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot Cory Carson®DJ
Train Trax & the Roll Train!
Get ready to dance with Cory, Chrissy and DJ Train Trax! Help
Cory and Chrissy dance on stage or roll DJ Train Trax to light up
his rainbow smokestack while building motor skills and listening to
sounds and phrases from the show. Wicky-wicky, woo-woo!
DJ’s Parking Spot
Hat Button PlayZone LocationMixing Table
Turntables

3
INCLUDED IN THIS PACKAGE
Toot-Toot Cory Carson®DJ Train Trax & the Roll Train
NOTE:
This toy is not intended for teething.
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy and should be discarded for your child’s safety.
NOTE:
Please keep this Parent`s Guide as it contains important information.
One DJ Train Trax One mixing table
Parent’s Guide
One mini Cory
One mini Chrissy

4
Removing the packaging locks
GETTING STARTED
Battery Removal and Installation
DJ Train Trax
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of DJ Train Trax. Then, use a
screwdriver to loosen the screw and
remove the cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for
maximum performance).
5. Replace the battery cover and tighten the screw to secure.
Turn the packaging lock anticlockwise
several times.
Pull out the packaging lock and discard.
Rotate the packaging lock 90 degrees
anticlockwise.
Pull out the packaging lock and discard.

5
Mixing Table
1. Make sure the unit is turned OFF.
2. Locate the green battery cover on
the top of the Mixing Table. Then,
use a screwdriver to loosen the
screw and remove the cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (The
use of new alkaline batteries is
recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• Useonlybatteriesofthesameorequivalenttypeas
recommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging(if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
Formoreinformation,pleasevisit:
www.recycle-more.co.uk
www.recyclenow.com

7
PRODUCT FEATURES
DJ Train Trax
1. On/Off Switch
To turn DJ Train Trax ON, slide
the On/Off Switch to the ON
position. To turn DJ Train Trax
OFF, slide the On/Off Switch to
the OFF position.
2. Automatic Shut-Off
To preserve battery life, DJ Train Trax will automatically shut
off after approximately 35 seconds without input. The unit can
be turned on again by pressing the Hat Button or pushing DJ
Train Traxquickly.
NOTE:
This product is in Try Me mode in the packaging. After opening
the package, turn the unit off and on again to proceed with normal
play. If the unit powers down while playing, please install a new
set of batteries.
Mixing Table
1. On/Off Switch
To turn the Mixing Table ON, slide
the On/Off Switch to the ON
position. To turn the Mixing Table
OFF, slide the On/Off Switch to
the OFF position.

8
2. Automatic Shut-Off
To preserve battery life, the Mixing Table will automatically shut
off after approximately 35 seconds without input. The unit can
be turned on again by putting Mini Cory or Mini Chrissy on the
Mixing Table, twisting the Turntables,turning the Spinning
Handle or placing DJ Train Trax in DJ’s Parking Spot.
NOTE:
This product is in Try Me mode in the packaging. After opening
the package, remove Mini Cory and Mini Chrissy, place DJ
Train Trax in DJ’s Parking Spot or take out and reinsert the
batteries to proceed with normal play. If the unit powers down
while playing, please install a new set of batteries.
ACTIVITIES
DJ Train Trax
1. Hat Button
Press the Hat Button to hear
fun sounds, songs, phrases and
melodies. The smokestack will flash
with the sounds.
2. Sounds and Melodies
Push DJ Train Trax to hear fun
sounds. While a melody or song
is playing, continue pushing DJ
Train Trax to add in fun sounds
on top of the melody or song. The
smokestack will flash with the
sounds.

9
Mixing Table
1. PlayZone Location
Place Mini Cory, Mini Chrissy
or other Toot-Toot Cory Carson®
mini characters on the PlayZone
Location to trigger fun sounds,
short tunes and phrases.
2. Spinning Handle
When Mini Cory and Mini Chrissy
are on the Dancing Platforms,
turn the Spinning Handle or twist
the Turntables to watch them
dance.Lights will flash with the
sounds.
3. DJ’s Parking Spot
Place DJ Train Trax in DJ’s
Parking Spot to press the button
and trigger fun sounds and short
tunes. The lights will flash with the
sounds.
4. Turntables
Twist the Turntables on the
Dancing Platforms back and
forth to hear fun sounds, short
tunes, phrases and a song. If a
short tune or song is playing, twist
the Turntables back and forth
to add fun sounds on top of the
music. The lights will flash with the
sounds.