V-tech Toot-Toot Friends Magic Lights Castle Assembly Instructions

Parent’s Guide
91-003712-004 UK
Magic Lights Castle

2
2
2
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot FriendsTM
Kingdom Magic Lights Castle! Place Princess Poppy and Prince
Louie on the MagicPointTM location to hear fun sounds and music.
Press the Heart Button to open up the stairs with fun sounds and
colourful lights. Celebrate and have fun with Princess Poppy and
Prince Louie in this beautiful light up castle!
Clock
Bells
Princess
Poppy
Prince
Louie Bed Mirror
MagicPointTM
Location
6 Instrument
Buttons
Dancing Floor
Light Up Stairs
Door
Heart
Button
Cat

3
3
3
INCLUDED IN THIS PACKAGE
NOTE: This toy is not intended for teething.
• One character - Princess Poppy
• One character - Prince Louie
• Two pillars
• One ground floor base and dance floor
• One ground floor main wall
• One 1st ground floor
• One single tower roof
• One triple tower roof
• One small pillar
• One clock

4
4
4
• One book support cover
• One book page
• One chandelier
• One big flag
• Two small flags
• Two doors
• One cat
• One bed
• One mirror
• One label sheet
• One parent’s guide

5
5
5
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE: Please keep this parent’s guide as it contains important
information.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION – Magic
Lights Castle
1. Make sure the unit is OFF.
2. Locate the battery cover on the top left of
the 1st floor base. Use a screwdriver to
loosen the screw.
3. If used or spent batteries are present,
remove these batteries from the unit by
pulling up on one end of each battery.
4. Install 2 new AA (LR6/AM-3) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
Battery Notice
• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.

6
6
6
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate that the
battery contains more than the specified value of mercury
(Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com
CAUTION:
Adult assembly required. For your child’s safety, do not let your child
play with this toy until it is fully assembled.

7
7
7
WARNING:
Once the toy is fully assembled, only the book support cover and
the chandelier can be disassembled. Do not attempt to disassemble
other parts of the toy as this may damage the toy.
ASSEMBLY INSTRUCTIONS
With the VTech®Toot-Toot FriendsTM Kingdom Magic Lights
Castle, safety comes first. To ensure your child’s safety, adult
assembly is required.
1. Insert the two Pillars into the Ground Floor Base as shown in
the picture. You will hear a click when the pieces are secure.
Note: Carefully check the shape of pillars and ensure you are
inserting them into the correct holes.
2. Insert the Ground Floor Main
Wall into the Ground Floor Base
as shown in the picture. You will
hear a click when the pieces are
secure.

8
8
8
3. Attach the two Doors to the doorframe of the Ground Floor
Base as shown in the picture.
Note: Attach the upper edge of the Door to the upper section of
the doorframe first. Then, attach the under edge of the Door to
the under section of the doorframe.
4. Insert the 1st Floor Base into the
Ground Floor Main Wall as shown
in the picture. You will hear a click
when the pieces are secure.
5. Attach the Single Tower Roof to
the Triple Tower Roof to create the
big tower roof.

9
9
9
6. Insert the Small Pillar into the
platform of the Triple Tower Roof
as shown in the picture. You will
hear a click when the pieces are
secure.
7. Attach the Clock to the Triple
Tower Roof as shown in the
picture. You will hear a click when
the pieces are secure.
8. Insert the big tower roof and the
Small Pillar into the 1st Floor
Base as shown in the picture. You
will hear a click when the pieces
are secure. Then, insert the triple
tower roof into the holes of the
staircase and press down firmly.
You will hear a click when the
pieces are secure.
9. Attach the Book Page to the Book
Support Cover as shown in the
picture.