V-tech V.Smile Motion Wireless Controller User manual

Thank you for purchasing the V-Motion
tm
Active Learning System. Please
read the User’s Manual carefully before playing.
Connecting to the Console - One-Player Mode
• Locate the PLAYER 1/OFF/PLAYER 2 Switch on the bottom of the controller.
Move the switch to PLAYER 1. (Figure 3)
Note: When only one wireless joystick is connected, please set the controller to PLAYER 1.
• Make sure the controller’s Motion Sensor Signal is directly facing the
V-Motion
tm
console . (Figure 4)
• When the direction lights and the light on the
V-Motion
tm
console stop
blinking, the connection is complete. (Figure 5)
• Move the PLAYER 1/OFF/PLAYER 2 Switch to OFF when controller is not in
use. (Figure 6)
Connecting to the Console - Two-Player Mode
• Locate the PLAYER 1/OFF/PLAYER 2 Switch on the bottom of the controller.
Move the switch to PLAYER 2. (Figure 7)
• Repeat the steps above to be sure the controller is connected for PLAYER 2.
If you have a problem that cannot be solved by using this manual, we encourage
you to visit us online or contact our Consumer Services Department with any
problems and/or suggestions that you might have. A support representative will
be happy to assist you.
(Figure 7)
91-002299-001-000 (US)
Using the V-Motion
tm
Wireless Controller
( This is an update to page 8 of the User’s Manual )
(Figure 3) (Figure 6)(Figure 4) (Figure 5)