VAIMAS SRL Via Volpato, 39 36035 Marano Vicentino VI rev 1,3
GENERAL INFORMATIONS
The walker is a disabled aid, designed to give the body mobility support. It is
indicated in cases where the subject is unable to withstand sufficient safety and
when it is necessary to reactivate the deambulatory function.
TECHNICAL DATA AND INFORMATIOn
Frame in painted or chromed steel tube, diameter 25 with sub-axes adjustable in
width, height and depth.
- Handle height from floor 102 cm
- Adjustable height under axles from 118 to 145 cm
- Depth 82 cm
- East width max. 56cm
- Weight structure 9.1 Kg
- User weight max. 100 kg
ASSEMBLY
Equipment: No equipment required
Release the walker from the packs and open the chassis by
spacing each other's hips and favoring the opening of the
front cruise until it reaches the position allowing the insertion
of the center pushbutton insert by inserting the two locking
pins into the slots.
Now insert the shaped tubes on the flange tube (paying
attention to the direction), close the eccentric clamps by
moving the lever (Fig.). Insert the brackets under the axes on
the shaped tubes, at this point adjust the height of the support
by acting on the eccentric clamp.
Warning of pinching during the opening or closing phase of the walker, pay
attention
ASSISTANCE
In the event that some components, other than ordinary maintenance, deteriorate,
contact your distributor.
The technicians will be at your disposal for any problems you should present,
advising you the most appropriate solution. 24 months warranty