Valerie objects V9015031M User manual

safety directions
Max
25W
1x E27
220-240V
50-60HZ
0,5m
protection class 1:
the fitting must be earthed
instruction manual
hanging lamp n°4
V9015031M (brass) / V9015031B / Z
the maximum wattage indicated
in each lighting unit, for example,
must not be exceeded
for indoor use only, where direct
contact with water is impossible
this luminaire was designed to
work only with the indicated
voltage
observe the indicated minimum
distance between the lamp and
the illuminated materials/objects
the armature can be used in
combination with a dimmer.
consult the sales outlet for the
correct type
not to be disposed with domestic
waste in rubbish bin, bring it to a
staging area for electrical waste
Please study the instruction manual carefully before installing or using this product.
Keep this user manual for further reference / two persons needed for installation.
1.
2.
3.
4.
5.
6.
7.
8.
The luminaires may only be installed by authorized and qual ed technicians according valid regulations for electrical istallation.
Maintenance of the luminaires is limited to their surfaces. During maintenance no moisture can come into contact with any areas of
the terminal connections or voltage control parts.
Take account of the minimal separation distance from other objects and the room required around the fitting.
If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may
be installed only by registered installers.
When replacing a lamp, wait for it to cool, for a minimum of 5 minutes.
Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components.
Take account of all available technical information.
If the external exible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufaturer or his service
agent or a similar qual ed person in order to avoid a hazard.
18002000
1480200500
737
900
ø 250
15

2.
2.
assemble these two parts of the back part
1.
screw back part
of wall bracket into
the wall plug
(by hand)
3.
take care:
do not screw the wall
brackets tight, in order
to turn the hanging
lamp
5.
the ring
rests on the
upper wall
bracket
screw carefully the
frontpart of the wall bracket
on the back part (by hand)
make sure the spacers
are in between
4.
screw back part of
wall bracket into
the wall plug (by hand)
3.
75 mm
ø 10 mm
drill two holes with the
requested diameter (ø 10 mm) for the appropriate
wall plugs according your type of wall
2.
1. 2. 3.
1. 2.
3.
1.
2.
3.
1.
2.
3.
1x hanging lamp
(frame + power cord)
1x lamp shade 1x Led bulb silvered cap
4W - 350lm
2700 K (dimmable)
energy class A+
www.valerie-objects.com
2x set wall brackets
+ spacers
(wall plugs included)