Vassilias R-8056 User manual

CERAMIC FAN HEATER
INSTRUCTION MANUAL
MODEL NO.: R-8056
PLEASE READ ALL INSTRUCTIONS BEFORE USING

Type Specification Voltage Frequency Power
R-8056 Remote control 220-240
V～
50HZ 2000W
IMPORTANT SAFEGUARDS
Thank you for buying our product. Please attentively read this
before operating the machine. Keep this operation manual for
future reference.
1.The unit should be hung on the wall and make the wind outlet down or
laid on level. You must not place it precipitately or tipsily.
2.Please do not use the heater in the place where full of combustible or
explosive gas. Don’t cover the wind outlet.
3.If the supply cord is damaged, it must be replaced by the manufacture
or its service agent or a similarly qualified person in order to avoid a
hazard
4.The unit must not be located immediately below a fixed electrical-outlet.
The electrical-outlet must be equipped with installment of earth whose
capacity should 250V-10A or exceed 250V-10A. The socket and the
power plug should be in good connecting condition.
5. If nobody is in or you are repairing the heater, please put off the plug-in
6. Please don’t touch the unit by the wet hand or other conductor when
it’s working..
7. Motor is out of order, please make it stop immediately.
8. During using the heater, please do not continually open the door or
window otherwise it will influence the heating effect.
9 .If want to close the machine, press the on/off switch to off, then the
machine keep the fan working about 30 seconds until it blowing out

cool wind, then machine will stop working and you can put off the
plug-in.
10. Must hang the heater on the wall and fix it away from water in
bathroom.
11. Remote control, please use 5# battery, is matched with the unit.
If the product needs repair, please ask for special person or our
company authorized maintenance department.
POSITIONING OF THE APPLIANCE
Get two holes on the wall 1.8meters above the floor and near the corner
more 20mm, be sure to make the diameter just as same as the expanding
pipe. Fix two screws on the expanding pipe, keep the tips of the screws
out for 10mm, and hang up the machine after the screws are fixed
enough.

OPERATING INSTRUCTIONS
1. The unit was made of high quality plastic shell, firmness and
durable. PTC ceramic heater elements, high efficiency heating,
noiseless, odor-free, non-polluting, no flame and no need
oxygen.
2. Plug into any 220~50 Hz, AC source. Power polity lamp is
bright, please use remote control or soft button setting time
and power.
3. During using if you feel room temperature is too high/ low, you
can press remote control panel “+” or “-” to adjust temperature,
LED will display “room temperature” or “regulation
temperature”.
4. Turn the heater on by press the button on control panel, The
unit will display the current room temperature, automatic into
“fan” mode, and blow the natural wind.
5. Upon turning the heater button again, the unit will set
the heater into low heat mode.
6. Pressing the heater button three times, the unit will set
the heater into high heat mode.
7. Pressing the heater button 4th time, the heater will
swing.
8. Pressing the heater button once again, switch off the
heater. To turn the heater off, Press the heater

button again, cycle operation.
Warning:
before removing the plug from the socket, switching off and
before work for 30-60 seconds for cool down condition
that protecting inner parts.
TIMER FUNCTION
This function will work in any mode. The time function allows you to set
the length of operation from 1 hour to 8 hours. Press the time button in
the control panel, press one time will increase the length of operation by 1
hour, most 8 hours.
OVERHEAT PROTECTION
The heater is protected with an overheat protection that switches off the
appliance automatically in case of overheat e.g. due to the total or partial
obstruction of the grids. In this case, unplug the appliance, wait about 30
minutes for it to cool and remove the object which is obstructing the grids.
Then switch it back on as described above.
SAFETY CONTROL
To avoid damage and danger by overheating, your heater is fitted with
super protector that switch as off the heater in the event of overheating
until the temperature drops to some extent.

CLEANING AND MAINTENANCE
1. If you don’t use the heater for a long time, please wipe the surface
and put it into the box. Lay the carton on the ventilated and dry place.
Humidity and force press was prohibited.
2. Wait for the machine being cool and pull out the plug, then clean it.
Wipe it clean with wet washcloth or cleaner. Never directly wash
with water, do not drop the water into the machine. Never clean it
with acids, chemical thinner, gasoline, benzene etc.
3. Before use it again, please check it and make sure the outlet
ventilation have no any sundries.
REMOTE INSTRUCTION MANUAL

Operation steps:
“”
Press the button the power will be on , the pilot lamp will be on and
cold wind blows out. Press again, the power will be off.
“FUNCTION”
You can select 2 powers 1000W/2000W through this button.
“TIMER”
press the button setting time ， 8 hours at most , it can be showed by the
display screen..
“+” and “-“
During using, press ‘+’& ‘-‘ controlling temperature. When the room
temperature rises to the regulation temperature, heater will stop heating.
When room temperature descend lower by 3 ℃ than regulation, heating
up again. Regulate temperature by ‘+’ ‘-‘. Start-up again, first time press
‘+’ ‘-‘, the temperature start from 25 ℃ ( then change according to last
regulation temperature), keeping between 49 ℃ and 10 ℃ . Each press
change 1 ℃ . When pressing ‘+’ & ‘-‘, display temperature from the
present room temperature switch to regulation temperature. Stopping
press key, redisplay the present room temperature.

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF
THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE
2002/96/EC.
At the end of its working life, the product must not be disposed of as
urban waste.
It must be taken to a special local authority differentiated waste collection
centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative
consequences for the environment and health, deriving form inappropriate
disposal and enables the constituent materials to be recovered to obtain
significant savings in energy and resources. As a reminder of the need to
dispose of household appliances separately, the product is marked with a
crossed-out wheeled dustbin.