Vax Swift V-055 Product information sheet

easy guide
Please read carefully before using your
cleaner. Always fully extend mains
cable before use.
V-055
Cylinder range

Parts checklist
Parts Accessories Optional accessories
1) Carry handle 9) Dusting brush 13) *TurboToolTM
2) On/off button 10) Upholstery tool 14) *Turbobrush
3) Cord rewind button 11) Crevice tool (* log on to www.vax.co.uk to buy on line)
4) Hose connection socket 12) Combination floor head
5) Dust container
6) Top cover release buttons
7) Carry handle release button
8) Telescopic extension tubes
4
5
11
912
13
14
10
3
1
2
7
6
8

Assembling the cleaner
21
fig. 1 To attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible hose into the hose
connection socket on the vacuum cleaner by pressing the two buttons on either side of the hose connection.
fig. 2 The telescopic extension tubes can be lengthened or shortened by pushing the button forward and sliding the
tubes apart or together as required.

Assembling the easy-reach tool system
Your Vax cylinder is equipped with easily-accessible tool storage. To assemble this, please follow these instructions.
fig. 3 The tool storage system fixing bracket is already in place on the extension tube.
Insert the holding tubes as shown until the tubes click into place.
fig. 4 Place the dusting brush (A), upholstery tool (B) and crevice tool (C) on the tubes as shown.
34A
C
B

56
Adjusting the combination head for carpets & hard floors
Your Vax cylinder comes equipped with a combination floor head that can be used on carpets and hard floors.
Flick the rocker switch to the appropriate position as detailed below.
fig. 5 Hard floor position (tiles, parquet floors, etc) – the brushes must be in the lower position. Press on the
rocker switch to lower them.
fig. 6 Carpet or rug position – the brushes should be raised. Press the rocker switch to raise them.