Velocifero MAD User manual

Assembly Instructions for Velocifero MAD
In order to make more efficient use of space, when
our vehicle is packaged and transported, some
parts are not installed, so you need to do simple
assembly by yourself. The installation process is as
follows:
Step 1: Open the packing box and confirm that all
the installation parts are there.
seat cushion
seat support
mannul

Step 2: Reset the steering column
The resetting of the steering column is also very
simple. Just to fix the steering column on the board
the following steps can be followed:
As shown in the picture below, when open the
Main body of vehicle
Charger

parking, the steering column fixing bolt, gasket,
spring pad and nut are through the upper plate.
First remove the bolts and nuts and place the
steering column upright on the upper plate of the
column.
Then position the quick release. As shown in mark
2 below, the quick release button should be stuck
to the corresponding hole position of the steering
column. Don't lock the quick release too hard.

Then, use the removed bolt to go through the
steering column and upper plate of the column,
add the gasket and the spring pad, then tighten the
nut, as shown in the figure below.
Finally, tighten the quick release.
Attention: When installing the steering column, do
not pull the cable too much to avoid damaging the
2

cable and joint, causing failure.
Step 3: Reset the handlebar
The unpacking state of the handlebar is shown
below. It's easy to reset it when you use it. Hold
the handle sleeve and turn the handle upward to a
horizontal position. The spring installed on the
handle will lock it automatically.
After resetting, it should be like figure below.

Step 4: Mount the seat cushion
Insert the mounting bracket tube of the seat
cushion into the corresponding position of the seat
support as shown in the figure below. Adjust the
quick release shown in mark 1 to tighten. When
adjust the height of the seat cushion, you will have
to operate the quick release too.
1

Step 5: Install the seat
The mounting of the seat cushion shall first remove
the seat cushion lock nut as shown in mark 3 from
the body of the vehicle.
Then install the seat cushion on the sleeve as
shown in figure 4. The base hole passes through
the retaining bolt as shown below.
3
4

Finally, screw the cushion lock nut.it turns to be
like figure below.

Step 6: Connect the cable
When MAD is packed, most of the electrical wiring
has been connected. Only the wire of battery,
speed limit, taillight and rear license lamp have not
been connected, so you have to connect them by
yourself. The method is very simple. You only need
to connect the corresponding electrical interface.
They are all very easy to tell as shown below.
1、battery connector
2
3
4
5
1

2、speed limit interface
3、horn interface
4、taillight interface
5、Rear license lamp interface
Connect all the wires and hide the joints under the
foot pedal.
After completing the above 6 steps, the installation
of the vehicle will be completed. However, you are
not done yet, there are still a few more things to
be done.
1. Insert the fuse.
The above figure shows the battery fuse interface 1
1
fuse