Vents-us PS Series User manual

WALL VENT
PS SERIES
INSTALLATION
TOOLS REQUIRED
Screwdriver Pencil
Screws 4 pc for 3/16”
openings
Dowel 4 pc for 1/4”
peningsDrill
1 DRILL A CORE HOLE INTHE WALL 2 INSERT THE TELESCOPIC AIR DUCT
Ø D
Ø D
Outdoor
Indoor
A
min 3°
The air duct end must protrude from outside for the distance A
that enables installation of the outer ventilation hood or grille.
For details, please refer to the installation instruction for the
ventilation hood or the grille.
Install the air duct with the minimum slope 3° downwards
outside.
Fill the gaps between the air duct and the wall with mounting
foam.
www.vents-us.com
Vents-US
400 Murray Road, Cincinnati, OH 45217, USA
Tel: [phone], Fax: [phone]
E-mail: [email protected]

3 DISASSEMBLE THE VENT 4 MARK FASTENING HOLES USING THE INNER GRILLE
5DRILL FASTENING HOLES 6 FIX THE BACK SIDE OF THE WALL VENT TO THE
MOUNTING SURFACE WITH SCREWS
7 INSTALL THE ROPE AIR FLOW REGULATOR 8 INSTALL THE FILTER, THE SLIDE LEVER FOR AIR
FLOW CONTROL AND THE FRONT PANEL
9 CONTROL THE SUPPLY AIR VOLUME USING THE
SLIDE LEVER OR THE ROPE REGULATOR
10 INSTALL THE OUTER VENTILATION HOOD OR
GRILLE
V-US154EN-01
www.vents-us.com
Vents-US
400 Murray Road, Cincinnati, OH 45217, USA
Tel: [phone], Fax: [phone]
E-mail: [email protected]