Vents-us PSS 102 User manual

www.ventsus.com MIU_69_(PSS_102)_-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
INSTALLATION GUIDE
Tools required
Pencil Drill Screwdriver Dowel Screws
IN-LINE CENTRIFUGAL FAN
PSS 102
MOUNTING
Installation of the built-in solar battery and external unit of ventilator
1. Typical Fan installation
250 ... 420
105
2. Disassemble the telescopic air duct and disconnect the connectors
3. Disassemble the front panel of the ventilator 4. Drill a core hole in the wall

www.ventsus.com MIU_69_(PSS_102)_-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
5. Mark fastening holes 6. Drill fastening holes 7. Insert the duct into the back of the front panel
8. Fix the back side of the front panel to themounting surface with screws 9. Install the front panel
Installation of the remote solar battery
10. Mark fastening holes 11. Drill fastening holes 12. Fix the mounting brackets to themounting
surface with screws
13. Fix the panel in the selected position 14. Set the panel at the desired angle
20°
40°
15. Fix panel with screws

www.ventsus.com MIU_69_(PSS_102)_-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
Changing the air flow direction
16. Turn the impeller 17. Remove the impeller
18. Insert the other side of the impeller 19. Turn the impeller to fix it

www.ventsus.com MIU_69_(PSS_102)_-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
Installation of the ventilator internal unit
20. Drill a core hole in the wall 21. Disassemble the front panel of the ventilator 22. Mark fastening holes
23. Drill fastening holes 24. Attach the duct to the air flow adjustment section
25. Connect the connectors and insert the air duct into the wall hole 26. Fix the back side of the wall vent to
themounting surface with screws

www.ventsus.com MIU_69_(PSS_102)_-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
Ventilator flow section adjustment
27. Set the pull-cord switch 28. Adjusting the air flow with a pull-cord switch
Closed
29. Adjusting the air flow with a pull-cord switch
Open
30. Fix the front panel of the ventilator

www.ventsus.com MIU_69_(PSS_102)_-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
Installation of the ventilator external unit
31. Remove the rear panel 32. Mark fastening holes 33. Drill fastening holes
34. Insert the duct into the back of the rear panel 35. Fix the back side of the rear panel to themounting surface with screws
36. To remote battery 37. Fix the rear panel