Vents-us TT 100 User manual

www.ventsus.com
MIU_05-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
INLINE MIXED-FLOW FANS
TT 100/125/150/200/250/315
INSTALLATION GUIDE
INSTALLATION
Tools required
Pencil Drill Screwdriver Dowel (4 pcs.) Screws (4 pcs.)
MOUNTING
Fans may be mounted either vertically or horizontally. An air duct at least 40 inches long should be connected to an inlet ange in case of horizontal fan mounting; a canopy
should be installed on an inlet ange in case of vertical mounting. Outlet ange should always be connected to an air duct.
min 40 inch min 40 inch
Typical installation of the fan

www.ventsus.com
MIU_05-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
1) Disconnect the fan from power supply.
2) Deinstall the xing brackets.
3) Remove the fan from the casing.
4) Mark holes on the wall.
5) Drill the holes and insert the expansion anschors.
6) Fix the fan.
7) Install the fan into the casing
8) Connect air ducts
1
4
7 8
5
6
2
3

www.ventsus.com
MIU_05-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
Connection of the fan and standard wall socket
120vAC, 60Hz
HOUSE POWER
S1
AUT OMATIC
SWITCH
GREEN
GROUND
SCREW
HOUSE JUNCTION BOX
EAR TH
GROUND
FA N
ST ANDARD
WALL SOCKET
MIN MAX
S TO P

www.ventsus.com
MIU_05-01
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
The fan must be connected using durable, insulated and heat-resistant cables and wires.
1) Disconnect the fan from power supply.
2) Remove the cover from the terminal block.
3) Remove the cable clamp.
4) Connect the cables according, install the cable clamp.
5) Install the terminal block cover
6) Сonnect the fan from power supply.
4
123
56
QF