Vents-us LD 100 User manual

www.ventsus.com MIU_02_LD-02
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
AXIAL FANS
LD 100/125/150
INSTALLATION GUIDE
INSTALLATION
Tools required
Pencil Drill Screwdriver Dowel (4 pcs.) Screws (4 pcs.)
MOUNTING
The fan is designed for horizontal and vertical installation on the oor, on the wall or on the ceiling.
JUNCTION
BOX
TO HOUSE
JUNCTION BOX
FAN
POWER
CABLE
CEILING
MATERIAL
CEILING
BEAMS
JUNCTION
BOX
FAN
POWER
CABLE
WALL
MATERIAL
TO HOUSE
JUNCTION BOX FAN
WALL
HOUSE AIR SHAFT
VENT PIPE
FAN
WALL
CEILING
HOUSE AIR SHAFT
1.

www.ventsus.com MIU_02_LD-02
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
S2
JUNCTION
BOX
120vAC, 60Hz
POWER SOURCE
STANDARD
WALL SWITCH
S1
AUTOMATIC
SWITCH
GREEN
GROUND
WIRE
TO FAN
TO S2
TO S1
AND
GROUND SCREW GREEN
GROUND
SCREW
HOUSE JUNCTION BOX
EARTH
GROUND
FAN
L
N
X
N
L
N
L
~120V 60Hz
X
S1
S2
120vAC, 60Hz
POWER SOURCE
S1
AUTOMATIC
SWITCH
GREEN
GROUND
SCREW
HOUSE JUNCTION BOX
EARTH
GROUND
FAN
N
L
N
L
~120V 60Hz
X
S1
STANDARD
WALL SOCKET
Electrical Connection of ventilation fan Electrical connection of ventilation fan and standard wall switch
2.

www.ventsus.com MIU_02_LD-02
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
S1
1
12
S1
Mounting steps:
Step 1 - Cut o power supply and make sure that the power is disconnected
3. 4.
5. 6.
7. 8.
9. 10.
Step 2 -Disconnect the front panel from the fan. Then remove the cover that covers
the control board (Fig. 5).
Step 3 - Mark and bore the fastening holes and install the fan (Fig. 6-8).
Step 4 - Install the front panel (Fig. 9) and the decorative panel on the fan casing. Step 5 - Provide power supply to the fan (Fig. 10).
Connect the fan to power supply in compliance with the wiring diagram (Fig. 2).