Vents-us VKM EC 100 User manual

www.ventsus.com MIU_VKM_EC-01
Bodor Vents, LLC DBA:VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
CENTRIFUGAL INLINE FAN
VKM EC 100/125/150/200/250/305
INSTALLATION GUIDE
Tools required
Pencil Drill (Ø 8 mm)) Screwdriver Dowel NTW 8/45 (4 pcs.) Screws 5x45 mm (4 pcs.)
MOUNTING
The air motion in the system must be as shown with the pointer of the fan casing.
In case of the vertical installation the intake spigot must be protected with a ventilation hood.
To attain the best performance of the fan and to minimise turbulence-induced air pressure losses while mounting connect straight air duct sections to the fan spigots.
Minimum straight air duct length:
qual to 1 air duct diameter on intake side
equal to 3 air duct diameters on outlet side
min D min 3D
D

www.ventsus.com MIU_VKM_EC-01
Bodor Vents, LLC DBA:VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
INSTALLATION STEPS
Disconnect the fan from power supply Install the xing brackets
Lean the fan against the installation place and mark the
|fastening holes
Drill the holes and insert the expansion anschors
Fix the fan Connect air ducts

www.ventsus.com MIU_VKM_EC-01
Bodor Vents, LLC DBA:VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
ACCESS TO THE TERMINAL BOX
Disconnect the fan from power supply Unscrew the 4 screws that x the terminal box lid
Route the cables through the cable glad and complete electric connection Install the terminal box cover again

www.ventsus.com MIU_VKM_EC-01
Bodor Vents, LLC DBA:VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: [phone]
e-mail: [email protected]
Connection of the fan to power supply is performed via the terminal block located in the terminal box attached to the fan casing in compliance with the wiring diagram and
designation of terminals.
For smooth air ow control it is recommended to use the speed controller R-1/010.
The speed controller is not included in the delivery set and is available as a specially ordered accessory.
L
N
PE
L
N
PE
1
2
3
+10V
0-10V
GND
+10V
CTR
GND
1
2
3
QF
The recommended fan
speed controller is Vents R-1/010.
EXTERNAL WIRING