VERITAS Small Drill-Press Table and Fence User manual

T-Bolts
Flat
Washers
Mounting
Plate
Existing
Table Fender
Washers
Hex Nuts
Flat
Washers
Existing
Table
Mounting
Plate
Hex Bolts
T-Nuts
Drill-Press Table
Caution: To use this product safely, always follow the safety
instructions that came with your power tool. As with any power
tool accessory, always wear eye protection and hearing protection.
Attaching Mounting Plate to Drill Press
Mounting hardware is supplied for drill-press tables with through slots and those
with blind T-slots.
Through Slots
1. Align the 3/4"center hole in the
mounting plate with the center hole
of existing table.
2. Insert T-bolts with flat washers in the
recessed slots in the mounting plate
and through slots in the table.
3. Install fender washers and hex nuts,
and finger tighten.
4. Adjust mounting plate position on the
table as needed.
5. Tighten the four nuts.
Blind T-Slots
1. Place a T-nut in each T-slot in the drill
press-table such that they align with
the slots in the mounting plate. This
may involve some trial and error.
2. Align the 3/4"center hole in the
mounting plate with the center hole
of existing table.
3. Insert hex bolts with flat washers in
the recessed slots in the mounting
plate and into the T-nuts in the table.
4. Finger tighten the bolts.
5. Adjust mounting plate position on the
table as needed.
6. Tighten the four bolts.

Connector Bolts
Table Top
Mounting
Plate
Fence
T-Bolts
Flat
Washers
Knobs
Pocket
1/8"Hex
Key
Levelling Screws
1/8"Hex Key
Machine Screw
1/2"
1/2"
1/2"
1/2"
4× Ø 3/16"THRU
Ø 7/16"
4"
4"
Insert Plate
Veritas Tools Inc. Ottawa ON K2H 1C2 Canada veritastools.com
© Veritas Tools Inc. 2020 360 INS-754_A
Attaching Table Top to
Mounting Plate
Position the table top on the mounting
plate and secure with four connector
bolts using the 4 mm hex key.
Insert Plate
The 4"× 4"insert plate helps to prevent
blow out in the back of a workpiece.
As the insert gets consumed, it can be
rotated to three additional positions.
Replacement insert plates can be made
from 1/4"thick plywood or MDF.
Levelling the Insert Plate
1. Loosen the machine screw using the
1/8"hex key.
2. Adjust the four levelling screws with
the hex key, one corner at a time, as
required to bring the insert plate flush
with the laminate surface.
3. Once the insert plate is flush
with the top, lightly tighten the
machine screw.
Note: The 1/8" hex key is stored in a
pocket just below the front edge of the
top. A magnet at the bottom of the pocket
keeps the hex key in place.
Installing the Fence
Secure the optional fence assembly
onto the drill-press table top using two
T-bolts, two flat washers and two knobs,
as shown.