Vestfrost CFKS 471 Operation manual

REFRIGERATORS
MANUAL OF INSTRUCTIONS FOR USE AND INSTALLATION

2
CONTENTS 1. Before starting the appliance.
2. How to use the appliance.
3. General advice on the use of the appliance.
4.Maintenance.
5. Has the appliance stopped working?
6.Safety.
7.Technical data.
8.Installation.
9. Change of hinge side.
1. BEFORE STARTINGTHE
APPLIANCE
Check that the cabinet is undamaged.
Please report any transport damage imme-
diately to your dealer.
Wash the cabinet and inner lining with a mild
unscented detergent and wipe it dry. Do not
use abrasive scouring powder, steel wool or
similar.
Connection to the electricity supply: See
head (7) and (8).
2. HOWTO USETHE
APPLIANCE Operating panel: See fig. (1).
1. Lamp.
2.Thermostat knob.
3. Indicator for the connection to the electric-
ity supply (green).
The thermostat knob is adjustable from 0
(stop) to 7 (coldest). Find the position of the
thermostat which gives you the desired
temperature. Start at position 4.
Defrosting
The evaporator is automatically de-
frosted.The defrosted water is led to a
tray on top of the compressor where it
evaporates.
Fig 1.
312

3
3. GENERAL ADVICE ONTHE
USE OFTHE APPLIANCE If the unit is not used for more than two days
it should be switched off and the doors
should be left open for ventilation to prevent
a bad smell in the unit.
The appliance is equipped with a high-
quality skin condenser.
Therefore, a slight heating of the sidewalls is
quite normal.
Lighting
This appliance is equipped with a device
which causes the light to switch off if the
door is open / left ajar for abnormally long
time.
When the door has been closed for a couple
of minutes, the device is cut off and the light
switches on in normal way again.
4. MAINTENANCE Only use an unscented detergent when
cleaning the cabinet inside.
Switch off the appliance and pull out the plug
when cleaning the cabinet.
The skirting board can be removed to faciliate
a vacuum cleaning of the floor.See fig. (1)
page 6.
Remember to clean the drain on the back wall
of the cabinet.
5. HASTHE APPLIANCE
STOPPEDWORKING? Before calling a service engineer, check that
the plug is properly plugged into the wall
socket.
The fuse is intact.
The power has not been cut off.
All controls are correctly set.
Mounting of lock for one-door
uprights
Aptional extras.

4
6. SAFETY Do not store explosive substances in the
cabinet, such as gas, cigarette lighters,
petrol, ether or similar.
Scrapped cabinets may become dangerous
to children at play.Therefore, remove the
doors or place the scrapped cabinet in such
a way that children cannot enter it.
7.TECHNICAL DATA This appliance meets the provisions of the
following directives: 89/336/EEC
(electromagnetic compatibility), 73/23/EEC
(electrical equipment designed for use
within certain voltage limits) as amended.
The rating plate, which is placed either at
the back or inside the appliance, see fig. (2),
provides various technical information as
well as type and serial number.
Fig 2.

5
See drawings page 6 and 7.
Install the cabinet in a dry place and so that
it is not exposed to direct sunlight or any
other source of heat.
Place the cabinet in a level position.This is
easily achieved by adjusting the adjustable
feet at the front edge of the base.The
cabinet should not rest against a wall on its
hinged side.When placing the cabinet on a
carpet or on a wooden floor you should
adjust it once more after some time as the
cabinet might settle in soft foundations.
The cabinets can be built in or put side by
side, see page 7.
For sufficient airflow around the cabinet it is
necessary to have a 50mm high air duct
right above the appliance, see fig. (1) .
Make sufficient space for door opening to
allow the shelves to slide out, see fig.(3).
The dimensions for building in are noted on
the drawings.
It is safest to place the earthed wall socket
above the appliance and at least 2 m above
the floor.
Any local installation rules for appliances of
this kind must be observed.
During a storm the electricity supply might
be cut off.
You should be aware of this when installing
the appliance in weekend cottages or
elsewhere where you would not immediately
observe that the power has been cut off.
Construction and details in the accessories
are subject to alteration without previous
notice.
8. INSTALLATION

6
Adjust the tilt of the unit
by turning the adjustable feet with
a spanner.
Fig. 1
Ì
ÌÌ
Ì

7
150
1850
min. 2000
Fig. 2
Fig. 3
25
min. 1040
min. 15
600
Fig. 4
25 mm
1550 150
min. 1700
CFKS 411
CVKS 611
CFKS 471
CVKS 671

8
1) Dismantle the top hinge.This one is
to be used later as top hinge at the
opposite side. Lift off the top door.
3)Ajustment of the top door: loosen the
screws in the hinge above the door,
loosen the hinge above the door and
turn the hinge to the wanted side.
Tighten the screws.
6) Move the handle.
9. CHANGE OF HINGE SIDE
2) Remove the kick panel.
The bottom hinge is dismounted at the
3 screws.The hinge is turned 180° and
mounted on the opposite side.
5) The kick panel is mounted.
4) Adjusting the bottom door: Loosen the
3 screws in the bottom hinge and push
the bottom hinge to the required side.
Tighten the screws and mount the kick
panel.

9
¬
≈
¿
¡
√
ƒ

10