Victorian Plumbing Brooklyn Dot GS014X7BT User manual

INSTALLATION INSTRUCTIONS FOR
BATTERY POWERED MIRRORS
Before installing this product pay special attention to these instructions. It is
recommended that this product is installed by a qualified electrician to IEE wiring
regulations (BS 7671) and current building regulations. These products can safely be
fitted into Zone 2. See lighting regulations diagram.
Battery mirrors are powered by 8 AAA battery. On the bottom of mirror is a handle knob
to pull out the battery box which stores the batteries. To change or insert battery kindly
follow the instructions mentioned in installation steps 4 in following page.
Make sure the mirror is powered off before replacing/inserting batteries.
Don't mix old & new batteries together. This can damage the product.
Cleaning Instructions
In order to maintain the quality finish of this product please do not use any abrasives or
solvents when cleaning this product. Use only a damp cloth for cleaning this product.
Do not allow water to stand on any part of the mirror.
Please clean any spillage that may affect the quality of the finish as described above.
Special Care
Care Should be exercised when cleaning this product. Although its finish is extremely
durable, it can be damaged by harsh abrasives and cleaning pads. To clean, use a light,
non-abrasive cleaning solution or cleaning polish.
V1.10.2022

Packing information & installation
Package content:
Battery powered
Mirror Screws
Manual
Attention: Installation and connection to electric wiring must be done by a professional
electrician in compliance with local and national requirements for electrical installations.
Never modify the construction or add any parts which are not offered as spare parts or
accessories by the manufacturer of the luminaire. Any unauthorized modification might
result in weak mounting and risk that parts of the luminaire can fall down from the wall.
V1.10.2022

××××
Installation Steps
Hanging the mirror
Installation Procedure
To ensure the normal use of this product, it is required you set out wires as per the regulations
of IEE at the installation places. This product should be installed on a wall suitable to hold its
weight. The installation must be carried out by a professional electrician and wrong
installation may lead to product damage and personal injury.
Installation Tools
Measuring tape Spirit level Drill Hammer Pencil
123
Screwdriver
Make certain the wall is solid
and suitable to safely
accommodate the mirrors
overall weight when installed.
Measure and mark with a
pencil, the position of the
fixing bracket, securing
screws & plugs, while
checking with a spirit level
that the bracket is perfectly
level.
Choose a drill with an
appropriate drill bit to make
the holes at the marked
places. (Use a special
ceramic drill if the wall
surface is made of ceramic
tiles).
Insert Rawl plugs into
drilled holes, and then
screw the hook into the
hole.
V1.10.2022

Hanging the mirror
5 6
4
Pull out the battery box on
the bottom of the mirror
and insert 8 AAA batteries.
Push the battery box into
position once the batteries
are inserted.
Hang the product on
the wall hook.
Finally simply press the
button to turn the
mirror, lights on and off.
Recycling and disposal
Please recycle the packaging in accordance with your local government regulations on waste
handling, and follow the same advice at the end of the products life.
For more Information
Visit: victorianplumbing.co.uk
V1.10.2022