Victrola THE EASTWOOD SIGNATURE User manual

PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY
BEFORE USE AND KEEP IT FOR FUTURE REFERENCE.
MODEL: VTA-73
INSTRUCTION MANUAL
EASTWOOD
THE
SIGNATURE

FCC Statement and Other Information
CONTENTS
Warranty 13

WARNING

SAFETY INSTRUCTIONS
• SILICONE SLIPMAT

Earbuds

Auto and Manual Stop Selection Switch: If this switch is
turned ON, The record will start spinning when the tone
arm moves over the record and the record will stop
automatically when playback is finished. If this switch is
OFF, the record will automatically begin to spin when the
unit is in “VINYL” function mode and the record will
continue to spin after playback is finished.
AUTO STOP
ON OFF

“Eastwood Signature”
VINYL STREAM™ - BLUETOOTH OUT OPERATION

How to Replace the Turntable Stylus (Replacement Stylus # ATN3600L)
Removing the Stylus from the Cartridge
1.
Place your fingers at the tip of the stylus
and push down to the direction “A”.
WARNING: When applying force to stylus,
too much may damage or break the cartridge.
2. Pull the stylus out toward the direction “B”.
Installing the Stylus
1. Hold the tip of the stylus and insert the other
edge by pressing toward direction “C”.
2. Push the stylus up toward direction “D”
until it locks at the tip.
Caution:
�Do not remove or bend the stylus needle.
�Do not touch the needle to avoid injury to your
hand.
�Turn off the unit’s power before you
replace the stylus.
�Keep out of reach of children.
Please note: The stylus should last about 300 hours under normal use. It is recommended
that the stylus be replaced as soon as you notice a change in sound quality. 78 RPM
records may accelerate stylus wear and may have to be changed sooner.